User manual NAVMAN SPEED 3100

[. . . ] SPEED 3100 log Installation and Operation Manual English . . . . . . . . . . . . . c o m NAVMAN FCC Statement Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a normal installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] To return to normal 6-1 Start countdown timer 1 If you are not in timer mode, press to go to timer mode (to adjust the start time, see section 6-3). The timer displays On briefly and starts counting down from the start time. to go to You can adjust the countdown timer to between one and ten minutes, in increments of one minute. When the timer is counting down, TIMER flashes at the top of the screen and in timer mode the time to go is displayed in minutes and seconds: Flashes 2 6-2 Stop and reset countdown timer 1 2 Press + . The timer stops and the time resets to the start time (see section 6-3). to go to + to Timer counting down 6-3 Adjust start time 1 2 The beeper sounds and any external beepers or lights operate: Four beeps at four minutes to go. Ten beeps at the end; the last beep is longer and marks the end of the countdown. In each case, the end of the last beep marks the exact minute. 3 Press one or more times to set the start time in minutes. The timer does not start now (to start the timer, see section 6-1). Timer set to 9 min NAVMAN SPEED 3100 log Installation and Operation Manual 9 7 Systems of several instruments Several NAVMAN instruments can be connected together to share data. There are two ways of connecting instruments together, NavBus or NMEA. For more information, refer to the NavBus Installation and Operation Manual. If the boat has a GPS instrument connected to the instruments via NavBus then you can set up the SPEED 3100 to use this for speed readings instead of a speed transducer (see section 9-1 for wiring and section 9-2, step 2 for setup). Note: The speed from a paddlewheel sensor is the speed that the boat is moving through the water. If a transducer is not fitted to the unit and the corresponding external data is not available then the displayed value will be 0 (for example, when using a GPS input for speed and no speed/ temperature transducer is fitted to any instrument on the NavBus then temperature displays as 0). 7-1 NavBus NavBus is a NAVMAN proprietary system that allows systems of multiple instruments to be built using a single set of transducers. When instruments are connected by NavBus: If you change the units, alarms or calibration in one instrument, then the values will automatically change in all other instruments of the same type. Each instrument can be assigned to a group of instruments (see section 9-2, step 3). If you change the backlight in an instrument in group 1, 2, 3 or 4 then the backlight will automatically change in the other instruments in the same group. If you change the backlight in an instrument in group 0 then no other instruments are affected. If an alarm sounds, mute it by pressing on any instrument which can display that alarm. NavBus and the SPEED 3100 If the SPEED 3100 does not have a speed/ temperature transducer fitted then the unit will automatically take speed and temperature readings from another instrument, via NavBus, if 7-2 NMEA NMEA is an industry standard, but is not as flexible as NavBus as it requires dedicated connections between instruments. Speed, temperature and log data are output by the SPEED 3100 and can be read and displayed by the NAVMAN REPEAT 3100 or other NMEA instrument. The SPEED 3100 can also receive GPS speed data (NMEA RMC) from any compatible NMEA GPS instrument - GPS speed must be selected (see section 9-2, step 2). 10 NAVMAN SPEED 3100 log Installation and Operation Manual 8 SPEED 3100 hardware 8-1 What comes with your SPEED 3100 The SPEED 3100 comes in several configurations. [. . . ] Ph: +31 182 320 522 Fax: +31 182 320 519 e-mail: info@plastimo. nl Website: www. plastimo. nl United Kingdom PLASTIMO Mfg. School Lane - Chandlers Ford Industrial Estate, EASTLEIGH - HANTS S053 ADG. Ph: +44 23 8026 3311 Fax: +44 23 8026 6328 e-mail: sales@plastimo. co. uk Website: www. plastimo. co. uk Sweden, Denmark or Finland PLASTIMO NORDIC AB. Ph: +46 304 360 60 Fax: +46 304 307 43 e-mail: info@plastimo. se Website: www. plastimo. se Spain PLASTIMO ESPAÑA, S. A. [. . . ]