User manual NAVMAN TRACKER 5600

[. . . ] TRACKER 5600 CHARTPLOTTERS Installation and Operation Manual English . . . . . . . . . . . . . c o m NAVMAN FCC Statement Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a normal installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] To insert a waypoint in the route: i Move the cursor to the chosen leg to insert the waypoint. To move a waypoint in the route: i Move the cursor to the waypoint to move. To remove a waypoint from the route: i Move the cursor to the waypoint to remove from the route. The waypoint is removed from the route, but the waypoint is not deleted. Review the route and check that the route does not cross land or dangerous water. Or, to delete the route that is being created: i Press MENU and select Delete. Creating a new route from the chart display While creating the route: Press or to change the range; scroll the chart by moving the cursor to the edge of the chart. A data box at the top, left of the display shows the route name and total distance. If the cursor is near a leg, it shows the length and bearing of the leg as well. If a leg does not start or end at an existing waypoint then a new waypoint will be created automatically (to change the new waypoint data, see section 9-2-7). To enter the first leg of the route: i Move the cursor to the start of the route and press ENT. To add a waypoint at the end of the route: i Press ENT. 5 6 7 8 3 4 22 Tip: The distance and bearing calculator can also be used to enter a course and save it as a route (see section 3-2). NAVMAN TRACKER 5600 Installation and Operation Manual B. Creating a new route from the routes display 1 In the routes display, press MENU and select Create. 3 To change the route name: i Select the route name at the top of the display and press ENT. 4 To insert a waypoint in the route: i Select where the waypoint will be: To insert the first waypoint in a new route, select Leg 1. To insert a waypoint at the end of the route, select the unused leg at the end of the list of waypoints. Otherwise, select the waypoint to insert the new waypoint in front of. As waypoints are inserted, the distance and bearing of each leg is shown automatically. If the route has more waypoints than will fit on the display, press or to see them. 5 To remove a waypoint from the route: i Select the waypoint to remove. 8 Display the route on the chart (see section 102-3) and check that the route does not cross land or dangerous water. 10-2-2 Editing a route Editing a route from the chart 1 In the routes display, select the route to edit. 2 The selected route is displayed on the chart, with a circle around the first waypoint. [. . . ] School Lane - Chandlers Ford Industrial Estate, EASTLEIGH - HANTS S053 ADG. Ph: +44 23 8026 3311 e-mail: sales@plastimo. co. uk Website: www. plastimo. co. uk Sweden, Denmark or Finland PLASTIMO NORDIC AB. Ph: +46 304 360 60 e-mail: info@plastimo. se Website: www. plastimo. se Spain PLASTIMO ESPAÑA, S. A. Avenida Narcís Monturiol, 17 08339 VILASSAR DE DALT, (Barcelona). [. . . ]