User manual NEFF S52L68X1EU

[. . . ] 26 Intended use dn et nI e s u Overall condition of the machine Special salt and rinse aid . 40 This appliance is intended for use in the home and domestic environments. Use the dishwasher only in the home and only for its designated purpose: for washing domestic dishes. This appliance is intended for use up to a maximum altitude of 4000 metres above sea level. Safety instructions yf tS e a sic nusi otrtn . [. . . ] Press programme button # until the factory set value : is indicated on the digital display h. Each time the button is pressed, the set value increases by one level; when the value of : has been reached, the display jumps back to : (off). Close the door. Timerprogram ing Timer programming * * depending on model You can delay the start of the programme in 1-hour steps up to 24 hours. Press P + or – button until the displayed time corresponds with your requirements. To delete timer programming, press the P + or – button until h : is indicated on the digital display. You can change your programme selection at any time until the programme starts. The LED for button # flashes and the digital display h displays the factory setting : . Each time the button is pressed, the set value increases by one level; when the value of : has been reached, the display jumps back to : . Close the door. Automatic switch off after end of programme or interior light* Automaticswitchof /interiorlight * depending on model To save energy, the dishwasher can be automatically switched off 1 min or 120 min after the programme ends. The interior light 1" comes on when the door is opened irrespective of whether the ON/OFF switch ( is switched on or off. If the door is open for longer than 60 min. , the light switches off automatically. The interior light 1" is lit only when the set value : is selected. is indicated on the digital display. Switching off the appliance Short time after the end of the programme: 1. Note When the programme ends, leave the appliance to cool down a while before opening it. This will prevent steam from escaping and causing longterm damage to your built-in furniture. 24 Operating the appliance en Interrupting the programme 1. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. Close the door. Changing the programme When the START button ` has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (Reset). Intensive drying The final rinse uses a higher temperature which improves the drying result. The LED for button # flashes and the digital display h displays the factory setting : . Press programme button # until the factory set value : is indicated on the digital display h. Close the door. Terminatingtheprogram e Terminating the programme (Reset) 1. [. . . ] Ensure that the drainage hose is not kinked, crushed or twisted and that there is no cover plate in the drainage to prevent the waste water from flowing out! Drinking water connection 1. Fasten the drinking water connection to the tap according to the installation instructions using the enclosed parts. Ensure that the drinking water connection is not kinked, crushed or twisted. When replacing the appliance, always use a new water supply hose. 38 Installation and connection Water pressure: At least 0. 05 MPa (0. 5 bar), maximum 1 MPa (10 bar). [. . . ]