User manual NIKON AF-S VR 200-400MM F/4G IF ED

[. . . ] M/A: Autofocus can be overridden by manually focusing with the focus ring. A/M: Autofocus can be overridden by manually focusing with the focus ring, but focus ring detection sensitivity is lower than in M/A mode. Use this mode to avoid canceling the AF setting by unintentionally moving the focus ring. 28-29) Focus distances can be locked and saved during autofocus (AF-L) and then recalled by pushing the "MEMORY RECALL" button. [. . . ] When mounted on Nikon digital SLR (Nikon DX format) cameras, such as the D2-Series and D50, the following applies. AF-S 500mm: the lens' picture angle is 3°20' and its 35 mm equivalent focal length is approx. ) AF-S 600mm: the lens' picture angle is 2°40' and its 35 mm equivalent focal length is approx. If the lens mount rubber gasket is damaged, be sure to visit the nearest Nikon authorized dealer or service center for repair. Set your camera's focus mode selector according to this chart: Cameras Camera's focus mode Autofocus with Autofocus with Manual focus AF manual override manual override (Focus assist (C/S) (AF priority) is available. Ring while lightly depressing the shutter release button or the AF start button on the camera or the Focus operation button on the lens. To cancel manual override, remove your finger from the shutter release button or the AF start button on the camera or the Focus operation button on the lens, and lightly depress the shutter release button to return to the autofocus mode. The position of the Focus operation buttons can be changed to suit your preference. For more details on this change, contact your nearest Nikon service center or representative office. 3 During autofocus, the focus can be locked while you are pressing the Focus Focus is locked while either of these buttons is pressed. 1) 2 Focus on a subject that you want to memorize the focused 6) and a beep sounds, indicating that the focused distance was stored in Fig. The tripod collar can be exchanged for a monopod collar by removing the tripod collar lock screw. After changing the tripod collar, make sure the screw is fully tightened. failure to fully tighten the screw could lead to accidents or damage to the lens and camera. For details on this procedure, contact your nearest Nikon service center or representative office. (AF-S 600mm: HK-35-1/HK-35-2) Two-part lens hoods (HK-35-1 for attachment to the front of the lens and HK-35-2 for attachment to the front of HK-35-1) are provided. Using the HK-35-1: First, loosen the lens hood screw on the HK-35-1, slip HK-35-1 onto the front of the lens, then tighten the screw. Attaching the HK-35-2: Loosen the lens hood screw on the HK-35-2, slip HK-35-2 onto the front of the HK-35-1, then tighten the screw. storing the lens hoods: First , reverse the HK-35-2 , and slip it back onto the HK-35-1. Then reverse the HK-35-1 with the HK-35-2 attached, and slide both back onto the front of the lens. A 52mm screwin NC filter is attached to the filter holder when shipped from the factory. 1 Screw a filter into the side of the filter holder marked with the words "Nikon" and "JAPAN". [. . . ] Wipe in a circular motion from center to outer edge, taking care not to leave traces or touch other parts of the lens. Never use thinner or benzene to clean the lens as this might damage it, result in a fire, or cause health problems. When the lens is not in use, attach the lens cap to protect the front lens element. When storing the lens in its lens case, attach both front and rear caps. [. . . ]