User manual NIKON MB-D100

[. . . ] To tighten Reverse the order of the above steps to remove the MB-D100. When attaching or removing the MB-D100, be sure the camera is off and that the MB-D100 control lock is in the locked position. â· When attaching a PB-6 bellows focusing attachment (available separately) to the D100, use the PB-6D and PK-13 auto-extension ring. [. . . ] When inserting LR6 (AA) batteries into the MS-D100 holder, insert them on an angle as shown in the illustration. When photographs are deleted using the Delete > Selected or Delete > All options in the playback menu, the associated voice memos will also be deleted. â· Do not use the MB-D100 with batteries of types not described in this manual. â· In the unlikely event that a problem should occur in the operation of this device, discontinue use immediately and take the equipment to a Nikon authorized service center or technician for inspection and repair. â· A short-circuit will result if the power terminals are brought into contact with metal objects. When inserting the MS-D100 holder into the MB-D100, first use the holder to hold the right- side clip in the open position as shown in the illustration, then insert the holder into the battery pack. The voice memo record/playback button (item 10 in Figure 1) is used for both recording and playback. The function performed depends on whether a recording already exists for the photograph displayed in the monitor (or, if no photographs are displayed in the monitor, whether a recording exists for the most recent photograph). During Recording While voice memos are being recorded, the voice memo record/playback lamp will glow orange and a (recording) icon will be displayed in the camera monitor. After Recording When recording is complete, the voice memo record/playback lamp will go out, and a (voice memo) icon will be displayed in the camera monitor. Photo displayed in monitor No voice memo present Voice memo present Record voice memo for photograph currently displayed in monitor Play back voice memo for photograph currently displayed in monitor No photo displayed in monitor Record voice memo for most recent photograph Play back voice memo for most recent photograph 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 Terminal cover Battery-chamber cover holder Signal contact 1 Holder for MB-D100 connector cover Mounting screw Signal contact 2 Ten-pin remote terminal Ten-pin remote terminal cap Built-in speaker Voice memo record/playback button Voice memo record/playback lamp Built-in microphone Battery-chamber cover latch Mounting screw knob AE-L/AF-L and focus area selector button Main command dial for taking photographs in vertical (portrait) orientation Power terminals Sub-command dial for taking photographs in vertical (portrait) orientation Shutter-release button for taking photographs in vertical (portrait) orientation Control lock Tripod mount MS-D100 holder for LR6 (AA) batteries The batteries can be removed from the holder by pushing on the batteries from the holes in the bottom of the holder. Before recording a voice memo, make sure that no memo already exists for the photograph on display. If a voice memo already exists, you will have to delete it before you will be able to record a new memo (see "Deleting Voice Memos"). If the monitor is off, a voice memo will be created for the most recent photograph on the camera memory card. While the voice memo record/playback button on the MBD100 is pressed, the voice memo record/playback lamp will glow orange*. To record a memo of one to twenty seconds in length, speak into the built-in microphone (note that the input volume for the built-in microphone can not be adjusted). [. . . ] To play a voice memo back, display the associated photograph in the monitor (photographs with voice memos are marked by a icon). If the monitor is off, the recording for the most recent photograph on the camera memory card will be played back. While playback is in progress, the voice memo record/playback lamp will glow green. [. . . ]