User manual NIKON MH-71 AC BATTERY CHARGER

[. . . ] If you attempt to recharge the battery while the internal temperature is elevated, the battery will not charge or will charge only partially. If you shake the MH-60 Battery Charger or touch the battery while the battery is charging, the resulting vibration or static electricity may in very rare instances cause the MH-60 to indicate that charging is complete although the battery is in fact not yet fully charged. [. . . ] If you shake the MH-60 Battery Charger or touch the battery while the battery is charging, the resulting vibration or static electricity may in very rare instances cause the MH-60 to indicate that charging is complete although the battery is in fact not yet fully charged. Should this occur, remove the battery and reinsert it into the MH-60 to continue charging. Should an abnormality or malfunction occur, discontinue use immediately and request repairs from your retailer or Nikon Service Bureau. the MH-60 is used to recharge Nikon EN-EL2 rechargeable lithium-ion batteries. Before use, read the warnings and other information in this manual and in the documentation for your Nikon EN-EL2 rechargeable battery. Federal Communications Commission (FCC) Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. To ensure proper operation, read this manual thoroughly before using this product. After reading, be sure to keep it where it can be seen by all those who use the product. * Take the charger and battery back to your retailer, or to your Nikon service representative. The Nikon MH-60 can be used to recharge Nikon EN-EL2 rechargeable lithium-ion batteries only. Once charging is complete, remove the EN-EL2 from the battery charger. Be sure to use the charger face-up as shown in Figure 2, and do not tilt the charger while charging. [. . . ] The Nikon MH-60 can be used to recharge Nikon EN-EL2 rechargeable lithium-ion batteries only. Once charging is complete, remove the EN-EL2 from the battery charger. [. . . ]