User manual NILFISK MAXXI 4S

[. . . ] The jet must not be directed at persons, animals, live electrical equipment or the washer itself. Wear appropriate protective clothing and eye protectors. General Use of the high-pressure washer is subject to the applicable local regulations. Besides the operating instructions and the binding accident prevention regulations valid in the country of use, observe recognised regulations for safety and proper use. 4 Do not direct the jet towards yourself or towards other persons in order to clean clothes or footwear. [. . . ] Any other use may damage the washer or the surface to be cleaned or may result in severe injury to persons. 2. 2 Operating elements See fold-out page at the end of these operating instructions. Electric cable Spray gun High-pressure hose Spray lance Supply water connection with water inlet filter 6 High pressure hose connection 7 Main switch 8 Wall bracket 1 2 3 4 5 6 3 Before starting the washer 3. 1 Installation environment 3. 1. 1 Temperature conditions The machine should be installed in a frost-free room. Concerning outdoor outlet points, it should be possible to close and empty that part of the line which is exposed to frost. The maximum ambient temperature for the machine is 40°C. 3. 1. 2 Conditions of distance Out of consideration for the cooling system of the machine and the accessibility of service, there must be wall space on both sides of the machine. 1550 mm to the upper edge of the machine. 3. 2 Mounting instructions ATTENTION: Beware that the machine weighs approx. Hold the mounting bracket against the wall and mark the hole positions. Mount the machine onto the bracket's four rubber feet and fasten with the enclosed washers and nuts. Hang the assembly of machine/bracket on the four pre-mounted screws and tighten. 7 3. 3 Setting up the machine CAUTION!Before using the machine for the first time, check it carefully to detect any faults or damage. If necessary, add oil (see chapter 8. 3 for type of oil). 3. 4 Connecting the high pressure hose 1. Attach the high pressure hose to the high pressure inlet by means of the quick coupling. 3. 5 Connecting the water supply See chapter 8. 3 Technical Data for required quantity of water and water pressure. In the case of poor water quality (sand, etc. ), we recommend that a fine water filter is fitted in the water inlet. N. B. : For permanent connection to the public drinking water supply, install the water break tank from Nilfisk-ALTO (art. 107360904). Do not connect the washer directly to the public drinking water mains. Obsererve the regulations of your water supply company to prevent backflow of water into the supply line. A connection is permitted, however: - briefly to a pipe interrupter with moving section - with a free outlet - water break tank 1. Lock the safety catch on the spray gun. 5. 2 Disconnecting supply lines 1. Close all outlet taps and/or remove hoses. 6 Maintenance 6. 1 6. 2 Maintenance plan Maintenance work After the first 50 operating hours Every six months or 400 operating As required hours Weekly 6. 2. 1 6. 2. 2 6. 2. 3 Cleaning water inlet filter Checking pump oil level Changing pump oil 6. 2. 1 Cleaning water inlet filter A water filter is fitted on the water inlet to prevent large particles of dirt from entering into the pump. Replace damaged filter. 10 6. 2. 2 Checking the pump oil level 1. If necessary, add oil (see chapter 8. 3 for type of oil). MAX MIN 6. 2. 3 Changing the pump oil CAUTION!Unscrew the oil drain plug (1) on the pump housing and dispose of the old oil in accordance with the disposal regulations. Oil grade and capacity see chapter `8. 3 Technical Data'. 11 7 Troubleshooting Fault Pressure drop Cause > Air in the system Remedy · Vent the system by operating the spray gun several times at short intervals. If necessary, operate the washer for a short time without the high-pressure hose connected. [. . . ] Do Certous 2658/1 MALAYSIA 193 00 Praha 9 Nillfisk-Advance Sdn Bhd Tel. : (+420) 24 14 08 419 Sd 14, Jalan KIP 11 Fax: (+420) 24 14 08 439 Taman Perindustrian KIP E-mail: info@alto-cz. com Sri Damansara 52200 Kuala Lumpur DENMARK Tel. : (+60) 3 603 6275 3120 Nilfisk-Advance A/S Fax: (+60) 3 603 6274 6318 Industrivej 1 9560 Hadsund MEXICO Tel. : +45 7218 2100 Nilfisk-Advance de Mexico, S. Nilfisk-ALTO Food division Tel: +52 55 2591 1002 (switchboard) Division of Nilfisk-Advance A/S Fax: +52 55 2591 1002 ext. 229 Blytækkervej 2 E-mail: info@advance-mx. com 9000 Aalborg Tel. : +45 7218 2100 NORWAY Nilfisk-Advance AS Fax: +45 7218 2099 E-mail: food. division@nilfisk-alto. dk Bjørnerudveien 24 1266 Oslo Tel. : (+47) 22 75 17 70 Fax: (+47) 22 75 17 71 E-mail: info. no@nilfisk-alto. com TAIWAN Nilfisk-Advance Taiwan Branch No. 5, Wan Fang Road Taipei Tel. : (+886) 227 002 268 Fax: (+886) 227 840 843 THAILAND Nilfisk-Advance Co. [. . . ]