User manual NILFISK SCRUBTEC R 571

[. . . ] 6, 557, 207 SCRUBTEC R 571 SCRUBTEC R 571 C SCRUBTEC R 586 READ THIS BOOK CAUTION: Read the Operator's Manual before using the appliance. This book has important information for the use and safe operation of this machine. Failure to read this book prior to operating or attempting any service or maintenance procedure to your ALTO machine could result in injury to you or to other personnel; damage to the machine or to other property could occur as well. You must have training in the operation of this machine before using it. [. . . ] NO SMOKING! To maintain the batteries in good condition, follow these instructions: 1. The correct level is between 1/4" (1/2 cm) below the bottom of the tube in each cell and above the tops of the plates. Check the level of the electrolyte each time you charge the batteries (see figure 5). Figure 5 NOTE: Check the level of electrolyte prior to charging the batteries. Be sure the plates in each cell are covered with electrolyte before charging. CAUTION: Irreversible damage will occur to the batteries if electrolyte does not cover the plates. Machine damage and discharge across the tops of the batteries can occur if the batteries are over filled. Do not use tap water as it may contain contaminants that will damage batteries. CAUTION: CAUTION: 2. Keep the tops of the batteries clean and dry. To clean the top of the batteries, use a damp cloth with a weak solution of ammonia or bicarbonate of soda solution. To clean the terminals and connectors, use a terminal and connector cleaning tool. Do not allow ammonia or bicarbonate of soda to get into the batteries. Keep the batteries charged. 3. CLARKE TECHNOLOGY Operator's Manual - SCRUBTEC R 571 / 571 C / 586 Page -11- How To Prepare the Machine For Operation How to Charge the Batteries WARNING: Charging the batteries in an area without adequate ventilation could result in an explosion. To prevent an explosion, charge the batteries only in an area with good ventilation. NO SMOKING! A B C WARNING: To charge the batteries, follow this procedure: 1. Connect the battery charger AC cord to a 15 amp (min) 120V properly grounded wall receptacle. Observe indicator light to ensure the charging process has started (see figure 6, A - Red, B Yellow, C - Green ). For color indications see figure 6A. Figure 6 A B C Recharging the Batteries The Scrubtec R comes with an on board charger. Observe indicator light to ensure the charging process has started (see figure 6, A - Red, B Yellow, C - Green ). For color indications see figure 6A. Figure 6A NOTE: Make sure you plug into a circuit that is not loaded by other equipment. WARNING: Never charge a GEL battery with an unsuitable battery charger. Carefully follow the instructions given by the manufacturer of the batteries and battery charger. A NOTE: To prevent permanent damage to the batteries, avoid their complete discharge. Never leave the batteries completely discharged, even if the machine is not being used. When recharging the batteries, keep the base support of the seat lifted. [. . . ] Figure 40 Figure 41 Figure 42 Page -28- CLARKE TECHNOLOGY Operator's Manual - SCRUBTEC R 571 / 571 C / 586 HOW TO CORRECT PROBLEMS IN THE MACHINE PROBLEM Insufficient water onto the brushes CAUSE The solution flow is not set There is no water in the solution tank. Increase flow with solution switch. The machine does not clean satisfactorily The brushes are worn. Need to use a different kind of brush/pad Check the brushes and replace if necessary. (the brushes have to be replaced when the bristles reach approximately . 59 inches (15mm height. ) Use a different kind of brush. For cleaning operations on floors where the dirt proves to be particularly resistant, we recommend using special brushes. [. . . ]