User manual NILFISK SQ 8

[. . . ] GENERAL Operation of this cleaner is subject to the applicable national regulations. In addition to these operating instructions and the binding regu lations on accident prevention applicable in the country of use, the generally acknowledged technical rules for safe and correct working must also be observed. If appliances are connected to the appliance plug socket, ensure that these appliances are also switched off when being connected to the appliance plug socket. The operating instructions and the safety precautions contained therein must be observed when using appliances connected to the appliance plug socket of the cleaner. [. . . ] Before cleaning and servicing the cleaner, always remove the mains plug. Carry out only maintenance operations described in these operating instructions. Always arrange the current-carrying parts (plug sockets, plugs and connectors) and lay extension leads so that the protection class of the cleaner is maintained. Never spray the top section of the cleaner with water: Danger for persons, danger of short circuits. Om apparater ansluts till aggregatanslutningen måste man se till att dessa Kabellängd m till 20 20 till 50 Tvärsnitt mm² 1. INTENDED USE When employed in accordance with its intended use, the industrial vacuum cleaner described in these operating instructions is suitable for picking up non-flammable, dry dusts and liquids. A) 1 2 3 4 Handle Filter cleaning button Appliance switch Green LED (ready for operation) 5 Yellow LED (clean filter element) 6 Inlet fitting 7 Dirt tank 8 Drainage hose with ball valve 9 Retaining clamp 10 Connection lead 11 Adapter for accessories, 50 mm diameter CAUTION!On delivery, the accessories are lying in the tank and must beremoved before the cleaner is used for the first time. Press the adapter for accessories with a 50 mm diameter into the push-in clip (Fig. D) ELECTRICAL CONNECTION The operating voltage shown on the rating plate must correspond to the voltage of the mains power supply. Ensure that the cleaner is switched off and insert the plug of the mains lead Into a properly installed and fused plug socket with earthing contact. PICKING UP DRY SUBSTANCES Before picking up dry substances, the bag-type filter should always be installed in the tank. It is then easy to dispose of the material picked up and the service life of the main filter element is significantly increased. Damp filter elements can clog more quickly when dry substances are picked up. For this reason, the filter element should be dried or replaced by a dry element before picking up dry substances. PICKING UP LIQUIDS Before picking up liquids, the bag-type filter must always be removed from the tank. If foaming is observed, stop work immediately and empty the tank through the drainage hose. SWITCHING ON THE CLEANER Two operating modes are possible: Switch position `I': The cleaner operates with reduced suction power. Switch position `II': The cleaner operates with maximum suction power (Fig. When moving the switch from position `I' to position `II' or vice versa, always leave it in the `0' position for at least 3 seconds. [. . . ] 5 minutes; if the cleaner does not start again automatically, contact the Service Dept. Switch off the cleaner and empty the tank through the drainage hose Clean (not with compressed air!Guarantee and warranty are subject to our General Conditions of Sale and Delivery. Voltage Mains frequency Power consumption Fuse Volume flow (air) Vacuum Measuring surface sound pressure level measured at a distance of 1 m in accordance with DIN 45 635, Part 1 (4/84) in a free field at max. [. . . ]