User manual OREGON SCIENTIFIC BAA898HG

[. . . ] TEMPERATURE WINDOW - Displays current, minimum or maximum indoor and remote temperature - Indicates temperature trend A3. HUMIDITY WINDOW - Displays current, minimum or maximum indoor and remote humidity - Indicates humidity trend - Displays the Comfort Level - Indicates when the battery of the remote sensor is low A4. ATMOSPHERIC PRESSURE WINDOW - Displays the current or historical (last 24 hours) barometric reading A5. TIME / DATE / ALARM WINDOW - Displays the current time, date (day, month, and year), daily alarm or Pre-alarm function B. [. . . ] Holding down either the up or down position will increase or decrease the value rapidly. Repeat the above steps to set the minute, year, day/month or month/day display format, month, day and language for day-of-week respectively. Press [ MODE ] button to confirm and exit the settings. LCD AND KEY-PANEL BACKLIGHT For easy viewing in the dark this unit is featured with backlight function on the LCD display as well as on the front key-panel. Also, this unit is specially designed so that the backlight can be operated differently no matter it is wall-mounted or being put on the table. For the language for day-of-week, you can select E for English, D for German, F for French, I for Italian or S for Spanish. The day-of-week can be expressed as an abbreviation in five different languages. The languages and their selected abbreviations for each day of the week are shown in the language chart below. Day-of-the-week Language English German French Italian Spanish Monday Tuesday Wed. Press [ ] or [ setting. ] buttons to make changes to the alarm hour ] and the minute will flash. The ALARM ON icon [ ] is shown and the alarm will active at the specified time. To deactivate the daily alarm function, press the [ ] button when the alarm time is displayed. To activate, press the [ ] button to display the alarm time again. ALARM AND SNOOZE FUNCTION When the daily alarm goes off, the backlight will be on for five seconds and the alarm-on icon will flash. To stop the alarm sound, press any button (expect [ MEMORY ] & [ CHANNEL ] buttons). If the [ SNOOZE / LIGHT ] button or stand-button is pressed, the snooze function will be triggered. The alarm sound will stop and the alarm-on icon will blink for eight minutes. To deactivate the SNOOZE function, press the [ ] button. Note: When changes are made to the minute, the seconds will start from zero. SETTING THE ALARM To set the Alarm: ] button to display the daily alarm time (the icon 1. ] for three seconds and the value for the 7 GB GB PRE-ALARM FUNCTION FOR CHANNEL 1 REMOTE SENSOR The alarm function also has a pre-alarm feature which can alert the user before the preset alarm time when weather condition changes. Press and hold the [ operating time interval for this pre-alarm function. Use the [ ] or [ ] button to select from the 4 time-intervals: 15, 30, 45 or 60 minutes. Press the [ function will be enabled automatically which is indicated by the appearance of the [ ] symbol. The [ ] symbol will disappear and [ - : -- ] will appear to indicate disable of this function. The pre-alarm will operate during the selected time interval before the daily alarm time. During the pre-alarm operating period, if the temperature recorded at Channel 1 remote sensor falls to or below 2. 0ºC, the pre-alarm will be triggered. [. . . ] Such treatment may result in malfunction, a shorter electronic life span, damaged batteries, or distorted parts. Doing so will terminate the unit's warranty and may cause damage. Read this instruction manual thoroughly before operating the unit. HOW TO RESET THE UNIT The [ RESET ] button allows you to return all settings to factory values. Accessing the slot is required only when the unit is not operating in a favorable way such as in the rare case of a malfunction. [. . . ]