User manual OREGON SCIENTIFIC BAA913HG-EN

[. . . ] [CHANNEL BUTTON CHANNEL] CHANNEL Displays the temperature and humidity readings of the indoor or remote sensor B2. [MEMORY BUTTON MEMORY] MEMORY Displays minimum and maximum temperature and humidity readings, and erases memory data B3. [AL / ] BUTTON AL Displays the daily alarm time and Pre-alarm time period, or changes the corresponding alarm time B4. [MODE BUTTON MODE] MODE Changes the display mode of the clock, and alters time/date setting B5. [. . . ] Insert the batteries strictly according to the polarities shown therein. Replace the batteries when the low-battery indicator of the particular channel lights up on the display. (Repeat the steps described in section "BEFORE YOU BEGIN") Note :Once a channel is assigned to a remote unit, you can only change it by removing the batteries or resetting the unit. HOW TO USE THE BACKLIGHT Press [ for five seconds. The backlight will be activated HOW TO SET THE CLOCK Press MODE and hold for three seconds. Use the UP(+) or DOWN(-) buttons to make a selection between a twenty-four hour display and a twelve hour display. Holding down either the up or down position will increase or decrease the value rapidly. 5 913hg-e. p65 5 04/30/2002, 5:59 PM German GB GB HOW TO SET AND ACTIVATE THE ALARM To set the Alarm Press [AL / ] button to display the daily alarm time (the icon "AL" AL will be displayed) Press [AL / ] and hold for three seconds, the value for the hour AL will flash. Press UP(+) or DOWN(-) buttons to make changes to the alarm hour setting. The ALARM ON icon [ ] is visible and the alarm will activate at the specified time. To deactivate the daily alarm function, press the DOWN(-) button when the alarm time is displayed. To activate, press the UP (+) button to display the alarm time again. PRE-ALARM FUNCTION FOR CHANNEL 1 REMOTE SENSOR The alarm function also has a pre-alarm feature which can alert the user before their preset alarm time if weather conditions changes. Press and hold the ALARM button for 3 seconds to set the operating time interval for this pre-alarm function. Use the UP or DOWN button to select from the 4 time-intervals: 15, 30, 45 or 60 minutes. The pre-alarm function will be enabled automatically which is indicated by the appearance of the [ ] symbol. To disable this function, press the DOWN button in the Pre-Alarm mode. The [ ] symbol will disappear and "-:--" will appear to indicate disable of this function. The pre-alarm will operate during the selected time interval before the daily alarm time. For example, if the daily alarm is set to go off at 7:00 am and the pre-alarm operating time interval is set to 45 minutes, the pre-alarm will start to operate at 6:15 am (45 minutes before 7:00 am). During the pre-alarm operating period, if the temperature recorded at Channel 1 remote sensor falls to or below 2. 0ºC, the pre-alarm will be triggered. The Pre-Alarm icon will flash and the backlight will be turned on for 5 seconds. An alarm sound will also go off for 2 minutes as that of the daily alarm and the snooze function will also be activated if the [ ] bar button is pressed. 6 ALARM AND SNOOZE FUNCTION When the daily alarm goes off alarm, the backlight will be on for five seconds and the ALARM ON icon will flash. [. . . ] Do not subject the unit to excessive: force, shock, dust, temperature, or humidity. Such treatment may result in malfunction, a shorter electronic life span, damaged batteries, or distorted parts. Doing so will terminate the unit's warranty and may cause damage. Read this instruction manual thoroughly before operating the unit. HOW TO RESET THE UNIT The RESET slot allows you to return all settings to factory values. [. . . ]