User manual OREGON SCIENTIFIC DS3868

[. . . ] The mode selections are: Standby, Normal, Continuous Capture, Self Timer, Clear Photos and Resolution Setting. To turn the camera on, slide the D ON/OFF switch to the "On" position. The ON/OFF slide switch is located under the battery compartment door. Note: To conserve battery power the DS-3868 will automatically default to Standby mode after 30 seconds of no activity. [. . . ] Unlock A and remove the B Battery Compartment Door to access the D ON/OFF slide switch. Press E MODE to activate the camera and select the desired camera mode. Note: After 30 seconds of no activity, the camera will default to Standby mode. Look through the N VIEWFINDER and make sure that you can see the subject clearly. The F PHOTO COUNTER will decrease by a value of one with each photo taken. After the beep sounds, the camera is ready to take another photograph. Important: When the maximum number of photos have been taken, F the PHOTO COUNTER will show "00. " If G CAPTURE is pressed when "00" is displayed, a series of short beeps will sound indicating that the maximum number of photographs have been taken. The photographs must be downloaded or cleared from the camera before more photographs can be taken. (See Downloading Photographs. ) Note: The DS-3868 will not take photos in low light conditions. When the light is too low for the DS-3868, a beep will be emitted when photo is attempted. I J Bottom View K Top View Connecting the Camera to Your PC 3. H Standby Normal/ High Resolution Continuous Capture Self Timer 1. Connect and install the H USB Cable (included) to the USB port of your PC. Open the I Camera Connection Cable Door and plug the cable into the PC Interface Jack. Position the camera where the L Front-View Viewfinder is facing the subject. Follow instructions provided in the Windows Netmeeting software for video conferencing function. Press the E MODE button to sequence through the camera modes High Resolution Low Resolution Clear Photos dh9/20/00 DS3868 Manual(ver. 1)/OSI-USA ¶´ 1 4/10/01, 10:09 am Installing the Software 1. Make sure that no programs, such as games or anti-virus software, are running on the PC. If programs are open, close and exit from the programs before going on to step 2. From the setup menu, choose what language you want the setup instructions to be in. To register the software, click on PROGRAMS/ ARCSOFT/REGISTER & UPGRADE. Important: If the setup menu does not automatically appear after inserting the CD-ROM in the CD-ROM drive, follow these instructions: In Windows, click on START and then click on RUN from the start menu. Follow the on-screen instructions to complete installation and registration. [. . . ] Batteries contain dangerous chemicals and if mistreated or improperly disposed of can cause harm, injury or damage. Do not open the camera casing or tamper with the camera's electronic components; doing so will void the camera's warranty. Downloading Photos To run the ArcSoft® software, from the main menu screen in Windows, click on "Start. " After clicking on "Start, " click on "Programs" and then on "ARCSOFT Photo Studio Suite. " Once the ArcSoft® menu appears, click on the program that you want to use. (See Connecting the Camera to Your PC. ) Slide the camera ON/OFF switch to the "On" position. Open the ArcSoft® software and from the main menu select and click on "Photo Base" to open. [. . . ]