User manual OREGON SCIENTIFIC RM868PA

[. . . ] time-zones: Pacific, Mountains, Central or Eastern F[ ] BUTTONS Change the value of a setting G [ SNOOZE ] BUTTON Activates the snooze function or turns on the back-light and clock projection H [RESET] BUTTON Returns all settings to default values I [PROJECTION ON] BUTTON Used with power adapter to enable continuous projection J[ ] [IMAGE ROTATION] KNOB 90º (left or right) image rotation K [180º ROTATION] BUTTON Flips the projected image horizontally L [FOCUS] KNOB Adjusts the focus of clock projection M 3 V DC JACK For AC power adapter installation N WALL - MOUNT HOLE O PROJECTOR POWER This unit can be operated by batteries or AC power alone as well as both together. Battery Installation: The unit uses two AA-sized (UM-3) 1. 5V batteries which is installed in the factory for you. Replace the battery compartment door. When the power level of the installed batteries is low or when only AC adapter is connected, the low battery indicator [ ] will light up. [. . . ] It is unlikely that you will want or need to manually set the Projection Alarm Clock. Should the need or desire to manually set the clock arise, please see section: How To Set The Clock & Calendar Manually . ABOUT RADIO RECEPTION When the unit is within range of its respective radio signals, its radio-control mechanism will override all manual settings unless radio reception is deactivated. After battery installation, the unit will start to search for radio signal automatically. When it is receiving radio signal, the radio-reception icon will start to blink. A complete reception generally takes about 2 to 10 minutes, depending on the strength 5 GB GB HOW TO ENABLE OR DISABLE AUTO-RECEPTION If you wish to disable the auto-reception of radio signal feature while the unit is within range, press and hold [ ZONE ] button for 2 seconds. The radio-reception icon on the display screen will disappear and the unit will NOT respond to radio signals. The radio-reception icon will be shown again and it will start blinking to initiate reception automatically. HOW TO SET THE CLOCK & CALENDAR MANUALLY 1. The hand of hour on the analog display will be adjusted simultaneously. The hand of minutes on the analog display will be adjusted simultaneously. Follow the same pattern to set the year, date format (month-day or day-month), month, day, and display language (English [E], German [D], French [F], Italian [I] or Spanish [S]) for day-of-theweek. You can select 12-hour or 24- Day-of-the-week Language English German French Italian Spanish Monday Tuesday Wed. The hand of minutes on the analog display will be adjusted simultaneously. ] icon will ] when the 10. Press [MODE/SET] to save the changes and exit. If changes are made during the process, the seconds will reset and start from zero. The unit will also save all changes and return to normal display automatically after the unit has been left idle for a minute. zone-times: Pacific (P), Mountain (M), Central (C) or Eastern (E), press the [ ZONE ] button. HOW TO USE THE DAILY ALARM An alarm will go off for 2 minutes in two-step crescendo patterns if undisturbed. The [ ] icon will flash, the back-light and the clock projection will be activated for 5 seconds. Pressing [ SNOOZE ] will activate the snooze function. SNOOZE FUNCTION When the snooze function is activated, the alarm will be muted temporarily and set off again after 8 minutes. [. . . ] This warranty does not cover product subjected to abuse, misuse, accidental damage or tampering. Upon return of the defective product, Oregon Scientific will at its discretion, replace the product with either a new or a tested reconditioned product. Should the product be out of warranty, the consumer may purchase directly from Oregon Scientific a replacement at reasonable cost plus shipping and handling. CAUTION -- The content of this manual is subject to change without further notice. [. . . ]