User manual OREGON SCIENTIFIC RMR606HGPA

[. . . ] CONTENTS Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Product Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Front View . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] For best results, install batteries in the remote sensor before the main unit. Humidity Area when the OUTDOOR humidity is shown. AC ADAPTER (MAIN UNIT) An AC Adapter is supplied for use with this product. The power jack is located on the back of the main unit. CHANGE SETTINGS 1. Press MODE to confirm. TABLE STAND The table stand is located on the back of the product, as shown below. Remote 7 RMR606HGPA_R5 7 9/3/04, 4:16 PM EN EN REMOTE SENSOR (THGR122NX) This product is shipped with a THGR122NX Thermo/ Hygro Sensor that collects Temperature and Humidity data. SETUP SENSOR Open the remote sensor battery compartment with a small Phillips screwdriver. Insert the batteries, matching the polarity as shown in the battery compartment. If you are using more than one sensor, select a different channel for each sensor. For best results: · Insert the batteries and select the channel and temperature unit before you mount the sensor. · Do not place the sensor more than 30 meters (98 feet) from the main (indoor) unit. · Position the sensor so that it faces the main (indoor) unit, minimizing obstructions such as doors, walls, and furniture. · Place the sensor in a location with a clear view to the sky, away from metallic or electronic objects. · Position the sensor close to the main unit during cold winter months as below-freezing temperatures may affect battery performance and signal transmission. You may need to experiment with various locations to get the best results. Because of this they will freeze in low temperatures of approximately 10°F. Disposable Lithium batteries have a much lower threshold for temperature with an estimated freezing range of below -40°F. The Liquid Crystal Display in outdoor thermometers will remain operational to -20°F with adequate power. 8 9/3/04, 4:16 PM SWITCH Channel 3. Place the sensor near the main unit. Press RESET on the sensor to initiate signal sending between the sensor and the main unit. The reception icon on the main unit will blink for approximately 3 minutes while it is searching for the sensor. (Refer to the Sensor Data Transmission section for more information. ) Close the remote sensor battery compartment. Secure the sensor in the desired location using the wall mount or table stand. 4. 5. RMR606HGPA_R5 8 Wireless ranges can be impacted by a variety of factors such as extremely cold temperatures. Extreme cold may temporarily reduce the effective range between the sensor and the base station. [. . . ] Observe the following guidelines: · Never immerse the product in water. · Do not subject the main unit to extreme force, shock, or fluctuations in temperature or humidity. · Do not mix new and old batteries or batteries of different types. · Remove the batteries if storing this product for a long period of time. [. . . ]