User manual OREGON SCIENTIFIC TR118

[. . . ] When using both timer channels, simply press the T1 or T2 button to note count down time remaining. Non-flashing (T1 or T2) indicates the count down time of the channel being displayed. 2 CHANNEL JUMBO DISPLAY CLOCK TIMER INSTRUCTION MANUAL MODEL:TR118 TIMER BUZZER ALARM 1. When timer counts to 00H, 00M and 00S, timer buzzer alarm will sound and timer will begin to count up in seconds with respective non-flashing timer channel indicator appearing in display. [. . . ] Count-up timer: Maximum count-up range is 99 hours, 59 minutes and 59 seconds at 1 second resolution. Individual buttons for HOUR, MINUTE and SECOND setting. BATTERY REPLACEMENT To replace exhausted battery, slide push the battery cover on backside in direction of arrow. Insert a now 1. 5V `AAA' battery as indicated by the polarity symbols (+&-) marked and close battery cover. If this happens, simply remove battery from the battery compartment and reinstall again. The Clock will resume normal operation. CLIP ATTACHMENT The timer can clip on thin board, belt or shirt pocket using the plastic clip on the backside of timer. MAGNETIC ATTACHMENT NORMAL TIME SETTING 1. Press the SEC button to reset second digit to zero when the second digits are within the 00-29 second range; pressing SEC button in 30-59 second range advances minute setting by 1 minute and resets second digits to zero. Whenever the clock button is pressed, the time of day will appear on the display. The timer can attach to iron or steel surface, using the magnet attached to the clip on the backside of the timer. TABLE TOP USE Use the clip and metal stand bar together to stand the clock/timer at an angle on any flat surface. SPECIFICATIONS Power: use 1 pc UM-4 or "AAA" 1. 5V battery Weight: 0. 18 lbs (without battery) Dimension: 2. 75" x 0. 75" x 2. 5" (LxWxT) 6. 7. CAUTION The content of this manual is subject to change without further notice. Due to printing limitation, the displays shown in this manual may differ from the actual display. The contents of this manual may not be reproduced without the permis sion of the manufacturer. 12/24 HOUR FORMAT SELECTION 1. To activate 24 hour format, in Clock Mode hold START/STOP button down for approximately 3 seconds, beep tone will indicate format change. To change back to 12 hour format, repeat step 1 above. COUNT-DOWN TIMER SETTING (SEE FIG. 1) 1. The numbers can be fast forwarded by holding the individual buttons down for 2 seconds. [. . . ] Should the product be out of warranty, the consumer may purchase directly from Oregon Scientific a replacement at reasonable cost plus shipping and handling. 4. 5. TIMER START/STOP 1. After time setting is ready, press START/STOP button once to activate timer. When timer is counting, press START/STOP button once and displayed timer channel will pause. [. . . ]