User manual PANASONIC CU-4E23JBE

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual PANASONIC CU-4E23JBE. We hope that this PANASONIC CU-4E23JBE user guide will be useful to you.


PANASONIC CU-4E23JBE : Download the complete user guide (19 Ko)

You may also download the following manuals related to this product:

   PANASONIC CU-4E23JBE (3007 ko)
   PANASONIC CU4E23JBE (758 ko)
   PANASONIC CU4E23JBE (767 ko)
   PANASONIC CU4E23JBE (760 ko)
   PANASONIC CU4E23JBE (800 ko)

Manual abstract: user guide PANASONIC CU-4E23JBE

Detailed instructions for use are in the User's Guide.

[. . . ] 7 OPERATION I DRY · COOL · FAN Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 I POWERFUL Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 I Adjusting the Air Flow Direction Adjusting the horizontal blade (flap) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 I Timer Operation OFF TIMER operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] To stop it, press it once again. ON TEMP TEMPERATURE/TIME adjustment buttons change the temperature or time setting. C AMPM TIME OFF-TIMER CLOCK ON-TIMER CANCEL CLOCK button (See page 7 "Preparation Before Operation - Setting the Clock) OFF TIMER button ON TIMER button (See page 10 "Timer Operation") AMPM FAN SPEED MODE TIMER CANCEL button cancels the timer setting. MODE selector button selects the operation mode. : DRY : COOL : FAN SWING POWERFUL FAN setting button selects the air flow rate setting. SWING button (See page 9 "Adjusting the Air Flow Direction") POWERFULL button (See page 8 "POWERFUL Operation") ARC417A24 <CS-MK180> MODE SWING POWERFUL SWING button (See page 9 "Adjusting the Air Flow Direction") ARC417A25 5 Preparation Before Operation Remote controller Setting the batteries Position and correctly!Address switch Operating the remote controller · To use the remote controller, aim the transmitter at the indoor · · unit. If there is anything to block signals between the unit and the remote controller, such as a curtain, the unit will not operate. The maximum distance for communication is about 7 m. 2 Receiver 3 1 1 2 3· Press with a finger and slide the back cover to take it off. Set the back cover as before. This will cause the figures on the display to flash. Set the clock at this point. To fix the remote controller holder on the wall 1 2 3 Choose a place from where the signals reach the unit. Fit the claw of the holder into the bottom of the remote controller, and push the remote controller onto the wall. Push. Remote controller holder · The address switch is used when two indoor units are to be installed in a single room. · If there is only one indoor unit in the room, it must be set to "1". · To install two units in a single room, consult the shop where you bought the air conditioner. Set. ATTENTION About batteries · Always replace two batteries at the same time. · Do not use manganese dry batteries since their use may cause a malfunction. Inside the air outlet, a fan is rotating at a high speed. Notes on flap angles selected, · When [SWING] is depends swinging range the flap on the operation mode. (See the figure. ) When [SWING] is selected in heating operation, the flap and the diffuser swing up and down in combination. · <CS-MK180> DRY· COOL Press SWING . " appears or · The diffuser is kept open in DRY or COOL mode. · Unless [SWING] is selected, you should set the flap at · · Every time the button is pressed, " disappears. NOTE . . . . . . . The louver automatically swings right and left. a near-horizontal angle and at a near-horizontal angle in COOL or DRY mode to obtain the best performance. In DRY mode, if the flap is fixed at a upward position, the flap automatically moves in about 60 minutes to prevent condensation on it. . . . . . . . To stop the louver at an angle you like, press No display SWING . · ATTENTION Always use a remote controller to adjust the flap angle. If you attempt to move it forcibly with hand when it is swinging, the mechanism may be broken. ATTENTION · Always use a remote controller to adjust the louver angle. If you attempt to move it forcibly with hand when it is swinging, the mechanism may be broken. 9 Timer Operation Timer functions are useful for automatically switching the air conditioner on or off at night or in the morning. You can also use OFF TIMER and ON TIMER in combination. I To cancel the timer: CANCEL Press . Then the TIMER lamp goes off. OFF TIMER operation that the clock correct. (See page 7. ) If not, Combining ON TIMER and OFF TIMER 1 2 3 OFF-TIMER · A sample setting for combining the two timers is shown below. (Example) Present time: 11:00 PM (The unit operating) OFF TIMER at 0:00 a. m. AM l l l l l AM l Display l l is displayed. [. . . ] The outdoor unit emits water or steam. Explanation This is to protect the air conditioner. You should wait for about 3 minutes. I In COOL or DRY mode · Moisture in the air condenses into water on the cool · surface of outdoor unit piping and drips. I This happens when the air in the room is cooled into mist by the cold air flow during cooling operation. I This happens when smells of the room, furniture, or cigarettes are absorbed into the unit and discharged with the air flow. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE PANASONIC CU-4E23JBE




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual PANASONIC CU-4E23JBE will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.