User manual PANASONIC CU-E21JKE

[. . . ] Otherwise, it may cause electrical shock or fire in case of malfunction. ⷠTurn off the power supply if the unit is not used for a long period of time. ⷠThis air conditioner is equipped with a built-in surge protective device. However, in order to further protect your air conditioner from being damaged by abnormally strong lightning activity, you may want to disconnect it from the power supply. [. . . ] Do not touch the air conditioner during lightning, it may cause electric shock. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. ⷠIn case of emergency or abnormal conditions (burnt smell, etc), turn off the power supply, and consult your nearest dealer. ⷠAfter long periods of use, make sure the installation rack is not damaged. "Instructions for end-user" for air conditioners: This air conditioner bears the above mark, indicating that electrical equipment should not be disposed of alongside general household waste. European Community countries (*), should have a dedicated collection system for these products. Do not try to dismantle the system yourself as this could have harmful effects on your health and on the environment as a result of incorrect waste handling. This dismantling and disposal of refrigerant, oil and other parts must be done by a qualified installer in accordance with relevant local and national regulations. Air conditioners must be treated at a specialized treatment facility for re-use, recycling and recovery and should not be disposed of in the municipal waste stream. The airflow direction can be adjusted as desired by using remote control. Both upper and lower horizontal airflow direction louvers are manually adjustable. When ON Timer is set, the unit may start earlier (up to 30 minutes) before the actual set time in order to achieve the temperature you preferred. ⷠIf there is a power failure, you can restore the previous setting (once power is resumed) by pressing the This setting provides a quiet environment by reducing the airflow noise. POWERFUL operation will run for 20 minutes, after that this operation will stop automatically. Temperature setting of 1°C higher in cool mode or 2°C lower in heat mode than the desired temperature performs a 10% power saving. To reduce power consumption during cool mode, close the curtains to prevent the sunlight and heat from coming in. And operations are available in all modes and could be cancelled by pressing the respective button again. When you want the air conditioner to turn ON or OFF automatically at a preset time. [. . . ] When you want the air conditioner to turn ON or OFF automatically at a preset time. ⷠDo not touch the aluminium fin, sharp parts may cause injury. Dry the filters thoroughly under the shade, away from fire or direct sunlight. For Heat mode, during start or low discharge temperature / For Cool mode, when setting temperature is achieved, the air is blown from the upper air outlet only. [. . . ]