User manual PANASONIC CU-HE9GKE

[. . . ] A ligao inadequada poder causar risco de choque elctrico s Do not install the unit in a place where there may be explosive gas leaks. No instale a unidade num local onde possam ocorrer fugas de gs explosivo Gas leaks near the unit could cause fires. If abnormal condition (burnt smell, etc) occurs, switch off and unplug the power supply. Do not insert finger or other objects into the indoor or outdoor units. [. . . ] Be sure the directions are correct Certifique-se de que a polaridade est correcta. Lights up Acende-se lights up Acende-se Can be used for approximately one year. Remove the batteries if the unit is not going to be used for a long period. Press to select the desired operation mode When pressed, the display changes in this order. Press to start the operation POWER indicator LED (Green) on indoor unit will light up. A Automatic Operation / Operao Automtica Display / Visor - Operation with 2C higher than standard temperature. Prima para reduzir a temperatura em 1C The temperature can be set between 16C and 30C. Once the Automatic Operation is selected, the indoor temperature sensor operates automatically to select the desired operation mode with Cooling or Soft Dry. After the operation mode have been selected, the mode does not change. Temperature is not displayed on remote control during Auto mode operation It does not lower the room temperature. The display changes in this order Prima para seleccionar a velocidade do ventilador The display changes in this order, Prima MANUAL When the room temperature reaches the setting temperature, operation commences at Low airflow volume. When cleaning with kitchen cleaning fluids (neutral detergents), rinse thoroughly. (Do not use non neutral detergents) Do not dry the front panel in direct sunlight. If the air conditioner operates with dirty filters:- Air is not purified - Cooling capacity decreases - Foul odours are emitted note: Catechin is natural brown element. The filter is coated with catechin in order to prevent the growth of bacteria and viruses. Lift up slightly then pull down 3 Hold the tabs of the airfiltros purificadores do ar e purifying filters and pull. You) new air purifying (Be sure is facing 3 Push untilat ouvir um click. Operation is normal if 15 minutes after the start of operation, the difference between the air intake and outlet vents temperatures is 8C or above for cooling. Dry the internal parts of the indoor unit, operate the unit for 2 - 3 hours using FAN operation. para secar as peas internas da unidade interior , opere o aparelho durante 2-3 horas , utilizando a FAN operao de ventilao. Note: If the unit is not switched off by the remote control, it will start operating when you plug in (because a Auto Restart Control is provided). The unit will become dirty after use over several seasons, reducing performance. [. . . ] "Beep", "beep" sound will be heard at the tenth seconds. Note: "Beep" sound will be heard at the fifth seconds; However please press continuously until you heard "beep" , "beep" sound. Note: If you press this button continuously for 5 to 10 seconds, Test Run operation will be performed. A "beep" sound will be heard at the fifth seconds, to identify the starting of Test Run operation. [. . . ]