User manual PANASONIC ER-HGP62

[. . . ] Denotes a potential hazard that could result in serious injury or death. Denotes a hazard that could result in minor injury or property damage. Do not immerse the appliance, AC adaptor and the charging stand in water or wash it with water. Do not place the appliance, AC adaptor and the charging stand over or near water filled sink or bathtub. [. . . ]      π     - The battery fluid may cause blindness if it comes in contact with your eyes. - The battery fluid may cause inflammation or injury if it comes in contact with the skin or clothes. π           Intended use • This clipper is designed for professional use to trim hair. € Before and after each use, apply lubrication oil at the marked places. ) Failure to apply the lubrication oil may cause the following problems. € Do not use any blade other than the one dedicated as it may cause defect in performance. Doing so may cause failure, cracking or discoloration of the main body. Clean the main body only with a soft cloth slightly dampened with tap water or soapy tap water. € You should not allow permanent wave lotion, hair dyeing or hair spray to come into contact with the main body or the blades. € Before using an attachment, check that it has been installed correctly.  A Main body  Power switch 2 Recharge lamp (Green) 3 Charge status lamp (Red) 4 Appliance socket B Blade 5 Mounting hook 6 Cleaning lever 7 Moving blade 8 Stationary blade C 3 mm/4 mm comb attachment D 6 mm/9 mm comb attachment E 12 mm/15 mm comb attachment   F Comb attachment shelves G Charging stand (RC9-87) 9 Charging plug : Stand socket H AC adaptor (RE9‑82)  Adaptor  Power plug  Cord  Appliance plug Accessories I Cleaning brush J Lubrication oil 9 ER-HGP62. Indb 9 2017/03/10 English 13:56:16 WARNING Parts identification Charging the clipper • Make sure that the clipper is turned off. When charging starts When charging is completed 10 minutes after charging is completed ER-HGP62. (for safety and to reduce energy usage) • Charging is required when the recharge lamp blinks. € The clipper can be used for approximately 5 minutes after the recharge lamp blinks. Notes • If there is noise from the radio or other sources while using or charging the appliance, move to a different location to use the appliance. € The battery will deteriorate if not used for over 6 months, so make sure to perform a full charge at least once every 6 months. € The charging time may differ when using the clipper for the first time, or if it has not been used for more than 6 months. The lamp on the main body may not glow for several minutes when first starting charging, but will glow when continuing to charge. • Recommended ambient temperature for charging is 10 °C – 35 °C. The battery may not charge properly or not at all under extreme low or high temperatures. € When the charge status lamp is blinking rapidly (twice every second), there is a charging malfunction. [. . . ] På indersiden og siden af 2 Tryk på afbryderkontakten for at tænde for klipperen. I så fald opfylder det kravene for det direktiv, som er blevet fastlagt for det pågældende kemikalie. Symbolforklaring Følgende symboler er brukt for å klassifisere og beskrive nivået for risiko, skade og skade på eiendom forårsaket når betegnelser blir ignorert og utstyret ikke brukes riktig. Følgende symboler brukes for å klassifisere og beskrive hvilken type instruksjoner som skal følges. [. . . ]