User manual PANASONIC ES-8249

[. . . ] ) [for ES8162] The charge status lamp will glow when the shaver is being charged. You can fully charge the shaver in 1 hour if the LED display shows 20%. the battery capacity monitor indicates the charge remaining in the battery. The unit can be used once or twice more after the "20" starts to blink. [. . . ] You can fully charge the shaver in 1 hour if the low battery indicator blinks (see fig. The unit can be used once or twice more after the low battery indicator starts to blink. Before travelling, charge it fully for 1 hour if you will not be taking the adaptor with you. In case your shaver is without charge, you may quick charge it for 1 shave in about 5 minutes. 1 (B)) To charge with the charging stand, connect the power cord to the charging stand. place the shaver into the stand , and plug the adaptor to the AC outlet. You can always store your shaver in the charging stand to maintain full battery capacity. Caution ­ The system outer foil is very thin and can be damaged if handled improperly. To avoid personal injury, do not use if the foil or other parts of the shaving head is damaged. Disconnect the power cord from the shaver, and push the On/Off switch to turn the shaver on. If you push and hold the On/Off switch for more than 2 seconds, it will activate the turbo mode for "sonic" vibration cleaning. Do not put a thick layer of shaving foam as it may affect shaver's performance. If the shaving head is clogged with foam, simply rinse it under running water. It is recommended that you replace the system outer foil at least once a year and the inner blade at least once every 2 years to maintain your shaver's cutting performance. To insert the new system outer foil, press down until it snaps into place. Place the trimmer at a right angle to your skin and move it downward to trim sideburns. Remove the inner blade one at a time by grasping it firmly at both ends and pulling straight away from the shaver. To insert the new inner blade, hold the blade one at a time at both ends and press downward until it snaps into the shaver. Please make sure that the battery is disposed of at an officially assigned location, if there is one in your country. How to remove the built-in rechargeable battery before disposal of the shaver (see fig. 12) WARNING: Do not attempt to replace the battery for the purpose of reusing the shaver. The battery in this shaver is not intended to be replaced by consumers. [. . . ] The battery in this shaver is not intended to be replaced by consumers. The procedure described below is intended only for removal of the rechargeable battery for the pur- Do not charge the shaver, where it will be exposed to direct sunlight or a heat source, or where there is a lot of moisture. The shaver and adaptor will become slightly hot during use or charging, however this is not a malfunction. Grip the adaptor when disconnecting it from an AC outlet; tugging on the power cord may damage it. [. . . ]