User manual PANASONIC KX-TG8422E

[. . . ] TG8421E(e). book Page 1 Tuesday, December 16, 2008 8:03 AM Operating Instructions Digital Cordless Answering System Model No. KX-TG8421E KX-TG8422E KX-TG8423E KX-TG8424E Model shown is KX-TG8421. Thank you for purchasing a Panasonic product. You must subscribe to the appropriate service offered by your service provider/telephone company. Please read these operating instructions before using the unit and save them for future reference. TG8421E(e). book Page 2 Tuesday, December 16, 2008 8:03 AM Table of Contents Introduction Model composition . 33 2 TG8421E(e). book Page 3 Tuesday, December 16, 2008 8:03 AM Introduction Model composition Series KX-TG8421 series Model No. [. . . ] i 1 {V}/{^}: "Add Bar List" i M {ih} 1 (centre of joystick) i # iMi~ Enter the phone number (24 digits max. ). {ih} By entering phone numbers: Viewing/editing/erasing bar call numbers 1 2 1 (centre of joystick) i # i M {V}/{^}: Select the desired entry. Helpline Tel. 01289 8333 27 TG8421E(e). book Page 28 Tuesday, December 16, 2008 8:03 AM Programming Note: L Calls are disconnected when the handset moves from one radio cell to another. Selecting a base unit When "Auto" is selected, the handset automatically uses any available base unit it is registered to. When a specific base unit is selected, the handset makes and receives calls using that base unit only. If the handset is out of range of that base unit, no calls can be made. Registering a handset to a base unit The supplied handset and base unit are pre-registered. If for some reason the handset is not registered to the base unit (for example, w flashes even when the handset is near the base unit), reregister the handset. 1 2 3 1 (centre of joystick) i N i M {V}/{^}: "Select Base" i M {V}/{^}: Select the desired base unit number, or "Auto". i M L The handset starts searching for the base unit. 1 2 3 Handset: 1 (centre of joystick) i N i M {V}/{^}: "Register" i M 2 times {V}/{^}: Select a base unit number. Base unit: Press and hold {x} for about 5 seconds, until the registration tone sounds. L If all registered handsets start ringing, press the same button to stop. L When the handset has been registered successfully, w stops flashing. 4 Deregistering a handset A handset can cancel its own registration (or the registration of another handset) that is stored to the base unit. This allows the handset to end its wireless connection with the system. 1 2 3 1 (centre of joystick) i !i M {3}{3}{5} {V}/{^}: "Cancel Register" i M L The numbers of all handsets registered to the base unit are displayed. Select the handset(s) you want to cancel by pressing the desired handset number. {V}/{^}: "Yes" i M 5 4 Note: L When you purchase an additional handset, refer to the additional 5 28 Helpline Tel. 01289 8333 TG8421E(e). book Page 29 Tuesday, December 16, 2008 8:03 AM Programming L A confirmation tone sounds as each handset number disappears. Setting the repeater mode 6 1 2 3 {ih} 1 (centre of joystick) i !i M {V}/{^}: "Repeater" i M {V}/{^}: Select the desired setting. i M i {ih} Cancelling a base unit A handset can cancel a base unit that it is registered to. This allows the base unit to end its wireless connection with the system. 1 2 3 4 5 1 (centre of joystick) i N i M {V}/{^}: "Register" i M {3}{3}{5} {V}/{^}: "Cancel Base" i M Select the base unit(s) you want to cancel by pressing the desired base unit number. {V}/{^}: "Yes" i M i {ih} Note: L After turning the repeater mode on or off, w flashes on the handset momentarily. This is normal and the handset can be used once w stops flashing. 6 Note: L To register a handset to another base unit or to the same base unit again, see page 28. Increasing the range of the base unit You can increase the signal range of the base unit by using a DECT repeater. [. . . ] Change the unit's number of rings setting or contact your service provider/ telephone company (page 42). If you have forgotten your remote access code, enter the remote access code setting to check your current code (page 40). Answer the call and try again later. My own greeting message cannot be properly heard. I cannot operate the answering system. I cannot operate the answering system remotely. While recording a greeting message or listening to messages, the unit rings and the operation stops. 56 Helpline Tel. [. . . ]