User manual PANASONIC KX-TG6432

[. . . ] Confirm that smoke has stopped emitting and contact an authorised service centre. Routine care L After cleaning away the dust on the lens, wipe the lens with a cotton bud. Conditions for using the cordless camera L The cordless camera is intended for indoor use only. L Do not use the cordless camera in the following places: ­ near incandescent lamps. [. . . ] This feature is useful when you mount the cordless camera upside down (page 15). Selecting the cordless camera speaker volume (DIP switch 3) If you want to lower the speaker volume, set to OFF (LOW). Symbols used in these operating instructions ­ while you are on a call with the handset. With a handset, you can monitor the image and sound of the room where the cordless camera is located. The monitored camera does not ring, allowing you to easily monitor a baby's room, for example, from different areas of the house. Important: L Before you start monitoring, confirm that the camera lens of the cordless camera has been adjusted to the correct angle. L A refreshed image taken by the cordless camera is displayed every few seconds. L While monitoring a cordless camera, other users cannot make an intercom call or transfer a call. l The monitoring connection is automatically cancelled after 10 minutes. L While monitoring you cannot place the handset on the base unit or charger. L The cordless camera may not page handsets in the following conditions: ­ when other users are on an intercom or conference call. (program) on the back side of the cordless camera with a pointed object such as a pen until a beep sounds. l When registration is completed successfully , the cordless camera beeps and the indicator stops flashing red but remains lit in yellow-green (page 5). L If all registered handset start ringing in step 2, press {x} to stop. The cordless camera can be mounted by the standard mounting or upside down mounting. CAUTION: L Mount the cordless camera on the stable location where the unit can be adequately supported when installing. l The AC adaptor should be connected to a vertically oriented or floor-mounted AC outlet. Do not connect the AC adaptor to a ceiling-mounted AC outlet, as the weight of the adaptor may cause it to become disconnected. L Do not mount the cordless camera on the following places: plaster board, ALC (autoclaved lightweight cellular concrete), concrete block, plywood less than 25 mm thick, and etc. L Do not pull the call button wire after you mount the cordless camera on the wall. L After mounting the cordless camera on the wall, speak loudly and clearly into the MIC when talking with the handset user. A Slide the cordless camera into the wall-mounting adaptor in the direction of the arrow until it clicks into the place. [. . . ] Mount the cordless camera (A), then slide it down (B) and to the left (C) until it is secure. About the screws for wall mounting L Use the recommended screw size below. L Drive the mounting screws leaving enough length from the wall to hook the cordless camera. L There is a strong sunlight or a backlight in the place where the cordless camera is located. [. . . ]