User manual PANASONIC KX-TG7432

[. . . ] 01289 8333 TGA820E(e). fm Page 3 Wednesday, May 30, 2007 6:52 PM Environment · Do not use this product near water. · This product should be kept away from heat sources such as radiators, cookers, etc. It should also not be placed in rooms where the temperature is less than 5 °C or greater than 40 °C. Warning: · To prevent the risk of electrical shock, do not expose this product to rain or any other type of moisture. [. . . ] Confirm that smoke has stopped emitting and contact an authorised service centre. · Do not place or use this product near automatically controlled devices such as automatic doors and fire alarms. Radio waves emitted from this product may cause such devices to malfunction resulting in an accident. from the AC adaptor/power plug by pulling it from the power outlet, then wiping with a dry cloth. Ensure that the AC outlet is installed near the product and is easily accessible. Battery caution · We recommend using the supplied battery(ies) or additional/replacement battery(ies) noted in the base unit's operating instructions. · Do not dispose of the battery(ies) in a fire, as they may explode. Check with local waste management codes for special disposal instructions. Released electrolyte from the battery(ies) is corrosive and may cause burns or injury to the eyes or skin. Do not allow conductive materials such as rings, bracelets or keys to touch the battery(ies), otherwise a short circuit may cause the battery(ies) and/or the conductive material to overheat and cause burns. - in a convenient, high, and central location. Battery installation/Battery charge Important: · Use only the supplied rechargeable batteries noted on page 2, 3. · Ensure correct polarities (S, T) when installing the batteries. · When installing the batteries, avoid touching the battery ends (S, T) or the unit contacts. 1 Press the notch on the handset cover firmly and slide it in the direction of the arrow. 2 Insert the batteries negative (T) end first. 3 Place the handset on the charger for about 7 hours before initial use. Note: · The handset display may show "Please Wait. . . " when the handset is placed on the charger if it is not registered to a base unit. · If you fully charged the batteries, but the operating time seems to be short, wipe the battery ends (S, T) and the unit contacts with a dry cloth. 01289 8333 5 TGA820E(e). fm Page 6 Wednesday, May 30, 2007 6:52 PM Registering the handset to the KX-TG8200/KX-TG8220 base unit Ensure that the handset is switched on. If it is not on, press and hold {ih} for few seconds to turn the handset on. 1 Lift the handset and press {ih}. 2 · Continue the operation even when the handset display shows "Please Wait. . . ". (No registration tone) {x} N KX-TG8220 Press and hold {x} on the base unit for about 5 seconds, until the registration tone sounds. {x} 3 With the handset still on the base unit, wait until a confirmation tone sounds and w stops flashing. Note: · If an error tone sounds, or if w is still flashing, register the handset according to the base unit's operating instructions. [. . . ] Note: · If an error tone sounds, or if w is still flashing, register the handset according to the base unit's operating instructions. · If all registered handsets start ringing in step 2, press {x} to stop. · Answering system features are available only when this handset is registered to the KX-TG8220. 6 Helpline Tel. 01289 8333 TGA820E(e). fm Page 7 Wednesday, May 30, 2007 6:52 PM Declaration of Conformity: · Panasonic Communications Co. , Ltd. [. . . ]