User manual PANASONIC WHSD28AE

[. . . ] This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. DEFINITION The instructions to be followed are classified by the following symbols: this symbol denotes an action that is PROHIBITED. To prevent personal injury, injury to others, or property damage, please comply the following. [. . . ] Incorrect operation due to failure to follow instructions may cause harm or damage, the seriousness of which is classified as below: Warning This sign warns of death or serious injury. Do not install, remove and reinstall the unit by yourself; improper installation will cause leakage, electric shock or fire. It is strongly recommended to check the operation of the RCCB after installation and periodically after servicing or maintenance by authorized dealer to ensure it is in good working order. Otherwise, it may cause electrical shock or fire in case of malfunction. Do not install the unit close to any combustible equipment or at bathroom. Do not touch the water discharge pipe at the indoor unit during operation. Do not press the buttons on the control panel with hard, pointed objects. Do not wash the control panel with water, benzene, thinner or scouring powder. If the power supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid hazard. During winter, please clean and remove the snow near outdoor unit so that the snow does no cover the air inlet and air outlet vents. inspection · In order to ensure optimal performance of the unit, seasonal inspections on the unit and field wiring have to be carried out at regular intervals. STATUS mode cannot be activated when the "SETTING" indicator is ON. When the outdoor temperature is out of the operation condition range, the heatpump system enter protection control. When heating is operated by indoor unit together with floor heating or panel heater simultaneously, there may be case where warm water temperature is getting lower and cause floor heating or panel heater heat-up is weaken. When outdoor air temperature is low, it may be difficult to get warm. When water outlet set temperature is low, it may be difficult to get warm. Due to the nature of the heatpump system, it may take some time to heat-up the water if the unit is operated from cold-start. Check if the unit has been installed at an incline or the cover is not closed properly. [. . . ] Due to the nature of the heatpump system, it may take some time to heat-up the water if the unit is operated from cold-start. Check if the unit has been installed at an incline or the cover is not closed properly. TURN OFF POWER SUPPLY then please consult authorized dealer under the following conditions: · These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic products should not be mixed with general household waste. For proper treatment, recovery and recycling of old products, please take them to applicable collection points, in accordance with your national legislation and the Directives 2002/96/EC and 2006/66/EC. [. . . ]