User manual PENTAX AUTO BELLOWS SLIDE COPIER K

[. . . ] Images taken with the purpose of obtaining copyrights also cannot be used outside the scope of use of the copyright as laid out in the Copyright Act, and care should be taken here also. Regarding trademarks · PENTAX and Optio are trademarks of PENTAX Corporation. · QuickTimeTM and QuickTime logo are trademarks used under license. · All other brands or product names are trademarks or registered trademarks of their respective owners. [. . . ] · You can continue shooting until the memory capacity of the SD Memory Card or built-in memory is full. · The interval of continuous shooting will vary according to the Recorded Pixels and Quality Level settings. · The number of recorded pixels is fixed at h in high speed continuous shooting mode. When Capture mode is set to R, the number of recorded pixels is set to V (1280×960). · The focus, exposure and white balance are locked with the first image. 77 10, 11 1, 2, 4, 5, 6, 7, 8 2, 3, 9 RAq<IBi\ExQX>yPDNJzR Taking Pictures at a Set Interval (Interval Shoot) 4 Taking Pictures 78 In this mode, a set number of pictures can be taken automatically at a set interval from a set time. Interval Set the camera to take pictures at one second intervals from ten seconds to four minutes or 10 sec. You cannot set the camera to take interval shots for less than ten seconds. However, 2 shots ­ number of this cannot exceed the number of recordable recordable images images. Set the start time in one minute intervals for when the camera is to begin interval shooting. start time is set to 0 min. , the first picture is taken as soon as the shutter release button is pressed. Number of Shot Start Time 1 2 Press the four-way controller (2) in A mode. Use the four-way controller (45) to select k (Interval Shoot) and press the 4 button. The current interval shoot setting appears for approximately five seconds. To take pictures with the current setting, go to Step 8. Drive Mode Interval Shoot OK OK 3 Press the 4 button while the setting is displayed. The Interval Shoot setting screen appears. For details of each display mode, refer to "Monitor Indications" (p. 18). · All the camera buttons function as normal even when the backlight is off. (p. 76) · In I, > or z mode, only I, > or z and the focus frame appear on the LCD monitor. In addition, you cannot change the information displayed on the LCD monitor by pressing the 4/W button. Normal Display 38 4 Taking Pictures Histogram + Info 38 OK 6M 200 +1. 0 03/25/2006 14:25 1/250 F3. 3 +1. 0 OK OK Backlight Off No Icons OK 83 Using the Histogram A histogram shows the brightness distribution of an image. The horizontal axis represents brightness (dark at the left and bright at the right) and the vertical axis represents the number of pixels. The shape of the histogram (Dark) Brightness (Bright) before and after shooting tells Dark portions Bright portions you whether the brightness and contrast are correct or not, and lets you decide if you need to use EV compensation and take the picture again. Setting the Exposure (EV Compensation) 1p. 82 Number of pixels 4 Taking Pictures 84 Understanding Brightness If the brightness is correct, the graph peaks in the middle. If the image is too dark, the peak is on the left side, and if it is too bright, the peak is on the right side. Dark image Correct image Bright image When the image is too dark, the part to the left is cut off (dark portions) and when the image is too bright, the part to the right is cut off (bright portions). Bright portions blink red on the LCD monitor and dark portions blink yellow. Displaying Shooting Information in Capture Mode 1p. 83 Displaying Shooting Information in Playback Mode 1p. 118 Understanding Contrast The graph peaks gradually for images in which contrast is balanced. The graph peaks on both sides but sinks in the middle for images with a large difference in contrast and low amounts of mid-level brightness. Setting the Shooting Functions 1 2 ARACY q<I BQiC\Ex QX>PDNJzR Selecting the Focus Mode Focus Mode = Standard Use this mode when the distance to the subject is 40 cm (16 in. ) or more. The camera is focused on the subject in the autofocus area when the shutter release button is pressed halfway. The camera is focused on the subject in the autofocus area when the shutter release button is pressed halfway. This mode is used when you ask someone to take pictures for you, or when taking pictures of the scenery through the window of a car or train. [. . . ] Pour les utilisateurs au Canada Cet apareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada. 9 Appendix 196 Declaration of Conformity According to 47CFR, Parts 2 and 15 for Class B Personal Computers and Peripherals We: PENTAX Imaging Company A Division of PENTAX of America, Inc. Located at: 600 12 th Street, Suite 300 Golden, Colorado 80401 U. S. A. Phone: 303-799-8000 FAX: 303-790-1131 Declare under sole responsibility that the product identified herein complies with 47CFR Parts 2 and 15 of the FCC rules as a Class B digital device. Each product marketed is identical to the representative unit tested and found to be compliant with the standards. Records maintained continue to reflect the equipment being produced can be expected to be within the variation accepted, due to quantity production and testing on the statistical basis as required by 47CFR §2. 909. [. . . ]