User manual PHILIPS 26HFL3232D

[. . . ] Switch your TV on / off or to standby Switch channels Watch connected devices Adjust TV volume Use teletext Back connector Side connector Connect a computer Use a Conditional Access Module Use Philips EasyLink Use a Kensington lock 5 Use more of your TV Access TV menus Rename devices from the home menu Remove devices from the home menu Change picture and sound settings Use the universal access menu Use advanced teletext features Create and use list of favourite channels Use the Electronic Programme Guide Use the TV clock Use timers Use TV locks Use subtitles View photos and play music from a USB storage device Listen to digital radio channels Update the TV software Change TV preferences Access decoder channel Start a TV demo Reset the TV to factory settings Trademarks are the property of Koninklijke Philips Electronics N. Philips reserves the right to change products at any time without being obliged to adjust earlier supplies accordingly. The material in this manual is believed adequate for the intended use of the system. If the product, or its individual modules or procedures, are used for purposes other than WKRVH VSHFLÀHG KHUHLQ FRQÀUPDWLRQ RI WKHLU validity and suitability must be obtained. [. . . ] Use the USB connector to view photos or listen to music stored on a USB storage device. [Slideshow transitions]: Sets the transition from one picture to the next. [Show info]: Displays the picture name, date, size and next picture in the slide show. If digital broadcasting is available, digital radio channels are installed automatically during installation. When listening to music, press OPTIONS to access one of the following music settings. >6KXIÁH RQ@ / >6KXIÁH RII@: Enables or disables random play of songs. [Show info] 'LVSOD\V WKH ÀOH QDPH [TV speakers] (Available only when you activate Easylink): Sets the TV speakers on or off. Caution Follow this procedure to avoid damage to your Philips continuously tries to improve its products and we recommend that you update the TV software when updates are available. If Professional mode is [On], your TV automatically receives software updates in semistandby mode without notice on screen. [Channel Information]: Displays information about the TV channel every time you switch channels. Select [Full] to view channel information or [Off] to turn off the channel information. [EasyLink]: Enables one-touch play and one-touch standby between EasyLink-compliant devices. You can use demonstrations to better understand the features of your TV. Before starting, make sure to turn PBS mode off for TV Demo to take effect: You can map channels provided through a decoder or descrambler to your TV channel selection. In this way, you can select these channels by using the RC of your TV. Select one channel to map to the decoder / descrambler channel and press OK WR FRQÀUP Select [Status], then press to enter. Select [None] if you do not want to map to This chapter provides instructions on how to UHLQVWDOO DQG ÀQH WXQH FKDQQHOV Press OK WR FRQÀUP » The TV starts to search and store all the available channels. When installation is complete, press OK to exit the installation menu. This section describes how to search and store channels automatically. You can enable automatic update of channels when your TV is in standby mode. The channels stored in your TV are updated every morning according to the channel information in the broadcast. Step 1 Select your menu language Step 2 Select your country Select the country where you are installing the TV. [. . . ] The TV does not switch on: Disconnect the power cable from the power outlet. The remote control is not working properly: Check that the remote control batteries are correctly inserted according to the +/- orientation. replace the remote control batteries if WKH\ DUH ÁDW RU ZHDN Clean the remote control and TV sensor lens. The standby light on the TV blinks red: Disconnect the power cable from the power outlet. [. . . ]