User manual PHILIPS AJ-3500

[. . . ] Unplug this clock radio during lightning storms or when unused for long periods of time. Referallservicingtoqualifiedservicepersonnel. Servicingis required when the clock radio has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the clock radio, the clock radio has been exposed to rain or moisture, does not operate normally, or has been dropped. This clock radio shall not be exposed to dripping or splashing. Safety · · · Do not place any sources of danger on the clock radio (e. g. [. . . ] to the voltage printed on the back or underside of the clock radio. Connect the power adapter to the wall socket. b Plug and set The clock radio has "plug and set" feature. When power is connected, the clock is set automatically. Select time zone Check if the time of the clock radio is consistent with the local time. » The current time zone number blinks on the display panel. 2 Press TIME ZONE repeatedly to select time zone. +8 +9. 5 +10(default) +12 For Australia: AustralianWesternStandardTime(AWST) AustralianCentralStandardTime(ACST) AustralianEasternStandardTime(AEST) NewZealandStandardTime(NZST) For United Kingdom and Ireland: Western European Time (WET) +0 (default) Set clock c In standby mode, you can set clock manually. Tip · In clock setting mode, press and hold HR/MIN for one second, and the hour/minute digits increase or decrease continuously. Select DST (daylight saving time) mode Forcountrieswithdaylightsavingtime(DST), theclockradiooffersyou DSToptiontoadjustsummertime. · Toselect12/24hourformat, press12/24H·DST repeatedly. 4 Set alarm timer Set alarm time d In standby mode, you can set two alarms to ring at different time. Note · In alarm setting mode, press and hold HR/MIN for one second, and the hour/minute digits increase or decrease continuously. Select alarm sound To select the last heard channel or buzzer as alarm sound, switch AL1/ AL2 RADIO·BUZZ to left or right. Tip · The gentle wake-up function is designed for all alarm sources. Activate/deactivate alarm timer 1 2 Press AL1/AL2 to view alarm settings. Note · When alarm sounds, you cannot adjust volume by rotating VOL. Snooze alarm When alarm sounds, press SNOOZE. To adjust alarm interval (in minutes), press SNOOZE repeatedly. 5 10 15 20 25 30 5 Listen to radio Tip Tune to radio stations e · Position the antenna as far as possible from TV, VCR, or other · For better reception, fully extend and adjust the position of the antenna. radiation source. Adjust volume f 6 Other features Set sleep timer This clock radio can switch to standby mode automatically after a preset period. To deactivate the sleep timer: 1 Press SLEEP repeatedly until [OFF] (off ) appears. 15 30 off 60 90 120 Adjust display brightness Press BRIGHTNESS repeatedly to select different brightness level: high, mid, and low. High Mid Low 7 Product information Note · Product information is subject to change without prior notice. Specifications Amplifier Rated Output Power 0. 6WRMS Tuner Tuning Range Sensitivity -Mono, 26dBS/NRatio SearchSelectivity Total Harmonic Distortion SignaltoNoiseRatio FM:87. 5-108MHz MW:520-1620KHz FM:<22dBu MW:<92dBuV/M FM:<28dBu MW:<98dBuV/M FM: <3% MW:<5% FM:>45dB MW:>40dB General information AC power Operation Power Consumption StandbyPowerConsumption Dimensions - Main Unit (W x H x D) Weight - With Packing - Main Unit 220-240V~, 50/60Hz < 3W <2W 179. 5x87x76mm 0. 65 kg 0. 49kg 8 Troubleshooting Warning · Never remove the casing of this apparatus. If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www. philips. com/welcome). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available. No power · Ensure that the AC power plug of the unit is connected properly. [. . . ] Correct disposal of your old product helps to prevent potential negative consequences for the environment and human health. Your product contains batteries covered by the European Directive 2006/66/EC, whichcannotbedisposedwithnormalhousehold waste. Please inform yourself about the local rules on separate collection of batteries because correct disposal helps to prevent negative consequences for the environmental and human health. Environmental information All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet. ) Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment. [. . . ]