User manual PHILIPS DCM5090

[. . . ] Do not mix batteries (old and new RU FDUERQ DQG DONDOLQH HWF Remove batteries when the unit is not used for a long time. Batteries (battery pack or batteries LQVWDOOHG VKDOO QRW EH H[SRVHG WR H[FHVVLYH KHDW VXFK DV VXQVKLQH ÀUH or the like. Do not place any sources of danger on WKH GHYLFH HJ OLTXLG ÀOOHG REMHFWV OLJKWHG FDQGOHV Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. 4 EN Warning Never remove the casing of this device. Keep this device away from direct sunlight, QDNHG ÁDPHV RU KHDW Never look into the laser beam inside this device. [. . . ] o 5(3($76+8))/( 6HOHFW UHSHDWVKXIÁH SOD\ PRGH p /LYLQJ 6RXQG Turn the Living Sound effect on/off. 'LVSOD\ 5DGLR 'DWD 6\VWHP 5'6 information. 3 Get started Caution Use of controls, or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of this device. ___________________________ Connect FM antenna Tip For optimal reception, fully extend and adjust the position of the antenna. Connect the supplied FM antenna to the FM $(5, $/ jack on the back of the main unit. 10 EN Connect power Caution Risk of product damage!Ensure that the power supply voltage corresponds to the voltage printed on the back or the underside of the unit. When you unplug the AC power cord, always pull the plug from the socket. Before connecting the AC power cord, ensure you have completed all other connections. 2 3 Close the battery compartment. a b Connect the power cord to: the AC~MAINS jack on the back of the main unit. the wall outlet. c Note If you are not going to use the remote control for a long time, remove the batteries. Do not use old and new or different types of batteries in combination. Batteries contain chemical substances, so they should be disposed of properly. Set clock Prepare the remote control Caution Risk of explosion!Keep batteries away from KHDW VXQVKLQH RU ÀUH 1HYHU GLVFDUG EDWWHULHV LQ ÀUH 1 In standby mode, press and hold PROG/ &/2&. Press / to select 12 hour or 24 hour format, and then press PROG/ &/2&. » The hour digits are displayed and begin to blink. 2 To insert the remote control battery: 1 Open the battery compartment. EN 11 English Insert 2 AAA batteries with correct SRODULW\  DV LQGLFDWHG 3 Press / to set the hour, and then press 352*&/2&. 6(7 WR FRQÀUP 4 Play Play from disc 1 2 Press CD on the remote control or press SRC repeatedly on the main unit to select CD source. Insert a disc into the disc compartment with the printed side facing right. » 7KH ÀOH VWDUWV SOD\LQJ DXWRPDWLFDOO\ , I not, press . Stop play During play, press to stop play. Skip to a track For CD: 1 Press / to select another track. To select a track directly, press a key on the numerical keypad. For MP3 disc and USB: 1 2 Press Press / / to select an album or folder. WR VHOHFW D WUDFN RU ÀOH Search within a track 1 2 During play, press and hold search within a track. / to 5HSHDW DQG VKXIÁH SOD\ 1 During play, press 5(3($76+8))/( repeatedly to select: UHSHDW RQH 7KH FXUUHQW WUDFN LV played repeatedly. VKXIÁH $OO WUDFNV DUH SOD\HG LQ a random sequence. 14 EN 2 Note 7KH UHSHDW DQG VKXIÁH SOD\ FDQQRW EH activated at the same time. Tune to a radio station Tip For optimal FM reception, fully extend and adjust the position of the FM antenna. 6KXIÁH SOD\ FDQQRW EH VHOHFWHG ZKHQ \RX SOD\ programmed tracks. Program tracks You can program a maximum of 20 tracks. 1 2 1 In CD/USB mode, at the stop position, press PROG to activate the program mode. / to Press TUNER on the remote control or press SRC repeatedly on the main unit to select the tuner source. » [SEARCH] VHDUFK LV GLVSOD\HG » The radio tunes to a station with strong reception automatically. 2 3 4 5 3 Press / to select a track number, and then press PROG WR FRQÀUP Repeat steps 2 to 3 to program more tracks. To erase the program, in the stop position, press . Repeat step 2 to tune to more stations. To tune to a weak station, press / UHSHDWHGO\ XQWLO \RX ÀQG RSWLPDO reception. Program radio stations Tip You can program a maximum of 20 preset radio stations. Display ID3 information Program radio stations automatically In CD mode, during play, press ID3 to display the following information: Track number Play time Title name Artist name Album name In tuner mode, press and hold PROG for more than two seconds to activate automatic program mode. [. . . ] Remote control does not work %HIRUH SUHVVLQJ DQ\ IXQFWLRQ EXWWRQ ÀUVW select the correct source with the remote control instead of the main unit. Insert the battery with its polarities (+/­ VLJQV DOLJQHG DV LQGLFDWHG Replace the battery. Aim the remote control directly at the sensor on the front of the unit. No disc detected Insert a disc. 8VH D ÀQDOL]HG &' RU FRUUHFW IRUPDW GLVF &DQQRW GLVSOD\ VRPH ÀOHV LQ 86% GHYLFH 7KH QXPEHU RI IROGHUV RU ÀOHV LQ WKH 86% device has exceeded a certain limit. [. . . ]