User manual PHILIPS GC2047/20 EASYSPEED PLUS

[. . . ] Note: Do not put perfume, vinegar, starch, descaling agents, ironing aids, chemically descaled water or other chemicals in the water tank. €¯2) 2 Fill the water tank up to the MAX indication (Fig. Temperature setting MAX 3 2 1 1 Steam setting ;, ;, ECO t t Steam boost Yes Yes No No No Spray Yes  Yes Yes No No Calc-Clean function IMPORTANT:To prolong the lifetime of your appliance and to maintain good steaming performance, use the Calc-Clean function once every two weeks. [. . . ] Troubleshooting This chapter summarises the most common problems you could encounter with the appliance. €¯If you are unable to solve the problem with the information below, visit www. Com/support for a list of frequently asked questions or contact the Consumer Care Centre in your country (see the worldwide guarantee leaflet for contact details). Problem Water drips from the soleplate or wet spots appear on the garment during ironing. Solution Set an ironing temperature that is suitable for steam ironing. The steam boost function does not work properly (water leaks out of the soleplate). You have used the steam boost function too often within a very short period. Water drips from the soleplate after the iron has cooled down or has been stored. When I push the steam control to the turbo steam position, the steam control jumps back. You have put the iron in horizontal position while there was still water in the water tank. Wait a while before you use the steam boost function again. 1 Consult table 1 to set the temperature dial to the appropriate setting for your garment (Fig. The temperature light goes on to indicate that the iron is heating up (Fig. 3 When the temperature light goes out, the iron has reached the correct temperature. 4 Consult table 1 to select a steam setting that corresponds to the temperature you have set (Fig. Note:To use turbo steam , keep the steam control pressed to the turbo steam position continuously. Set an ironing temperature at which the steam boost function can be used ( 2 to MAX). use the Calc-Clean function (see chapter ‘Cleaning and maintenance’ , section ‘Calc-Clean function’). [. . . ] €¯2) Cleaning and maintenance Cleaning 1 Set the steam control to t (dry ironing), unplug the iron and let it cool down. €¯2) 2 Pour any remaining water out of the water tank. 3 Wipe flakes and any other deposits off the soleplate with a damp cloth and a non-abrasive (liquid) cleaning agent. [. . . ]