User manual PHILIPS HD-7827

[. . . ] Table of contents Introduction 6 General description 8 Important 8 First use 11 Brewing SENSEO® coffee 12 Cleaning the machine 16 Descaling 19 Frost-free storage 22 Replacement 23 Environment 23 Guarantee and service 23 Troubleshooting 23 introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. This unique system combines the easy-to-use Philips SENSEO® coffee machine with the specially developed Douwe Egberts SENSEO® coffee pods, giving you a full, smooth coffee with a delicious foam layer. The Douwe Egberts coffee in convenient SENSEO® coffee pods and Philips' unique new SENSEO® brewing system are perfectly matched to ensure that the best taste and aroma are extracted from the coffee. [. . . ] - You can interrupt the brewing process at any time by pressing the on/off button 3. If you switch the machine back on after having interrupted the brewing process, the machine does not complete the interrupted brewing cycle. Do not remove the water reservoir during a brewing cycle, as this causes the machine to draw in air. Note: If no coffee comes out of the machine, you have not flushed the machine before first use. Flush the machine as described in chapter `Before first use' before you start brewing coffee. If only a small amount of coffee comes out of the machine, flush the machine as described in section `Flushing' in chapter `Cleaning' before you brew another cup of coffee. 5 Remove the coffee pod(s) after use by lifting the pod holder out of the machine and emptying it. Be careful when you do this, for there may still be some water/coffee on the coffee pod(s). Note: If you do not switch of the machine, it switches off automatically after 30 minutes. Switching off 1 After use, press the on/off button 3 to switch off the machine. Note: If you do not switch off the machine, it switches off automatically after 30 minutes. - Use the SENSEO® coffee pods that have been specially developed by Douwe Egberts for your SENSEO® coffee machine for a full, round taste. cleaning the machine Never immerse the SENSEO® coffee machine in water. Cleaning the coffee machine 1 Always unplug the machine before you clean it. Note:You can only remove the coffee spout after you have removed the coffee collector. 5 Disassemble the coffee spout if you want to clean it more thoroughly. 6 Clean the coffee spout, the coffee collector and the drip tray in hot water, if necessary with some washing-up liquid, or in the dishwasher. To clean the cup tray, always remove it from the machine, as it might prove sharp when handled incorrectly. If this is the case, unclog the sieve by rinsing the pod holder under a running tap. Note: If you use a washing-up brush, be careful not to damage the valve in the bottom of the water reservoir. 11 Rinse the parts with fresh water and put them back into the machine. Be careful when you do this; make sure that the rubber sealing ring does not get stuck under the edge of the water distribution disc. [. . . ] If it is, unclog the sieve by holding the pod holder under a running tap; the coffee pod has been put properly in the centre of the pod holder; the sealing ring has not got stuck under the edge of the water distribution disc (see figure 1 at the beginning of this user manual). The water drops on the worktop are not the result of placing or removing the water reservoir or removing used coffee pods. You do not remove the water reservoir when the coffee machine is heating up. This may cause water that normally ends up in the water reservoir to leak out of the machine. [. . . ]