User manual PHILIPS HD8705

[. . . ] If a used pod has been left in the coffee machine and you have not used the machine for some time, flush the machine before you use it again (see section `Flushing' in chapter `Cleaning'). This machine is intended for household use only and not for professional use. Water reservoir Lid of water reservoir 1-cup pod holder ° 2-cup pod holder °° Coffee spout Cover of coffee spout Drip tray Cup tray Water distribution disc Sealing ring Outflow valve Indicator light Important Read this user manual carefully before you use the machine and save it for future reference. Warning - Check if the voltage indicated on the bottom of the machine corresponds to the local mains voltage before you connect the machine. [. . . ] - You can interrupt the brewing process at any time by pressing the on/off button I. If you switch the machine back on after you have interrupted the brewing process, the machine does not complete the interrupted brewing cycle. Do not remove the water reservoir during a brewing cycle, as this causes the machine to draw in air. Note: If you only get a small quantity of coffee or no coffee at all out of the machine, you have not flushed the machine properly before first use. Flush the machine properly (see chapter `Preparing the machine for use') before you brew another cup of coffee. 10 After use, lift the pod holder out of the machine and remove the coffee pod(s). Be careful when you do this, for there may still be some water/coffee on the coffee pod(s). Tips , Rinse the pod holders and the coffee spout regularly to make sure that the coffee always tastes optimally. , The SENSEO® coffee tastes best if you stir it before you drink it. , If you intend to make another cup of SENSEO® coffee later, just leave the coffee machine switched on. 4 Clean the coffee spout, the pod holders and the drip tray in hot water, if necessary with some washing-up liquid, or in the dishwasher. 5 Hold the cup tray in your hand while you clean it with hot water, if necessary with some washing-up liquid. To clean the cup tray, always remove it from the machine, as it might prove sharp when it is handled incorrectly. if the sieve is clogged , unclog it by rinsing the pod holder under a running tap. Note:You can remove the cover of the water reservoir to clean the inside thoroughly. Note: If you use a washing-up brush, be careful not to damage the valve in the bottom of the water reservoir. 8 Rinse the parts with fresh water after cleaning and put them back into the machine. Make sure that the rubber sealing ring does not get stuck under the edge of the water distribution disc. Flushing If you have not used the coffee machine for three days, flush it with fresh water before you use it again. Flush the machine in the following way: 1 Fill the water reservoir with cold water up to the MaX indication and put it back onto the machine. 3 Put a bowl (with a capacity of at least 1500ml) under the coffee spout to collect the water. This takes some time and you will probably not notice that this happens. [. . . ] The SENSEO coffee machine brews only a small quantity of coffee or no coffee at all when it is used for the first time. Make sure that: you have used the correct number of pods and have pressed the right button. Use 1 pod in combination with the 1-cup pod holder ° and the 1-cup button °. Use 2 pods in combination with the 2-cup pod holder °° and the 2-cup button °°; you have placed the coffee pod(s) properly in the centre of the pod holder, to prevent water from escaping along the edge of the pod(s). [. . . ]