User manual PHILIPS HR7727

[. . . ] Do not exceed the maximum amounts and processing times indicated in the table. Wait until moving parts have stopped running before you remove the lid of the appliance. If the mains cord of this appliance is damaged, it must only be replaced by Philips or their service representative, as special tools and/or parts are required. Symbols on the appliance To the left of the symbols on the appliance representing the various applications you will find an icon of the accessory to be used. [. . . ] The citrus press accessories can only be used with the Philips HR 7727 food processor. Make sure that the projection of the sieve covers the opening in the handle of the bowl completely (fig. - Turn on the food processor and set the speed control to position 3 (fig. When you do so, switch off the appliance and remove the bowl along with the sieve and the cone. After use - Remove the bowl along with the citrus press accessories to prevent juice from leaking onto the appliance. You can then wash them in hot water with washing-up liquid or put them in the dishwasher. This does not have a negative effect; the discolorations usually disappear after some time. The juice extractor accessories can only be used with the Philips HR 7727 food processor. Turn the lid in the direction of the arrow until the peg of the safety lock snaps home in the motor unit (fig. Make sure that the projection of the lid covers the opening in the handle of the bowl completely (fig. How to use the juice extractor - Switch the food processor on and select the highest speed (position 5). - Drop the fruit or vegetables into the juice extractor through the chute (fig. Keep the pusher in the chute as much as possible to prevent spattering (fig. - Let the appliance run for another 20 seconds to obtain any juice still left in the fruit. - To avoid spilling juice on the appliance, remove the bowl along with the juice extractor accessories after use (fig. Before you use the juice extractor: - cut carrots, white radishes, etc. Always switch on the appliance before you put the fruit in the juice extractor. Switch off the appliance from time to time to remove pulp from the pulp sieve and the filter. Switch off the appliance if it starts to vibrate strongly and clean the pulp sieve and the filter before you switch it on again. The appliance can be used with or without the blender attached to the motor unit. If you use the appliance without the blender, the appliance will not function if the screw cap (S) has not been screwed onto the attaching hole for the blender. Before use: do not put the mains plug in the socket until you have attached the blender jar (V), the lid (U) and the knife unit (X) to the motor unit in the correct way. [. . . ] Problem: The switch does not function Possible solution: Turn bowl and/or lid in the direction indicated as far as possible (until you hear a `click'). Make sure that the arrows on the bowl and on the appliance as well as on the bowl and on the lid are placed directly opposite each other (see fig. Make sure that the blender jar or the screw cap have been properly placed and turn them in the direction indicated as far as possible. The appliance has suddenly stopped running This is probably the automatic cut-out system that has cut off the power supply to the appliance because it has overheated. [. . . ]