User manual PHILIPS HTS3111

[. . . ] All Rights Reserved. This product is in compliance with the essential requirements and other relevant provisions of Directives 2006/95/EC (Low Voltage), 2004/108/ EC (EMC). Mains fuse (UK only) This product is fitted with an approved moulded plug. Should it become necessary to replace the mains fuse, this must be replaced with a fuse of the same value as indicated on the plug (example 10A). The replacement fuse must comply with BS 1362 and have the ASTA approval mark. [. . . ] · Battery contains chemical substances, it should be disposed of properly. · The product/remote control may contain a coin type battery, which can be swallowed. Keep the battery out of reach of children at all times! · EN 3 English Product care Only use microfiber cloth to clean the product. Contact us Warning · Risk of electric shock. Never remove the casing of the product. Disposal of your old product and batteries Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. When this crossed-out wheeled bin symbol is attached to a product it means that the product is covered by the European Directive 2002/96/ EC. Please inform yourself about the local separate collection system for electrical and electronic products. Please act according to your local rules and do not dispose of your old products with your normal household waste. Correct disposal of your old product helps to prevent potential negative consequences for the environment and human health. To keep the warranty valid, never try to repair the product yourself. If you have problems using this product, register your product and get support at www. philips. com/ welcome. If you contact Philips, you will be asked for the model and serial number of your product. The model number and serial number are on the back or bottom of your product. ___________________________ Your product contains batteries covered by the European Directive 2006/66/EC, which cannot be disposed with normal household waste. Please inform yourself about the local rules on separate collection of batteries because correct disposal helps to prevent negative consequences for the environmental and human health. 4 EN 3 Your SoundBar Remote control English Congratulations on your purchase, and welcome to Philips!To fully benefit from the support that Philips offers, register your SoundBar at www. philips. com/welcome. Main unit 1 2 3 4 7 1 2 3 6 4 a · · (Standby-On) Switch the SoundBar on. When the SoundBar is on standby, the standby indicator is red. 5 b SOURCE c Select an audio source. +/- (Volume) Increase or decrease volume. [. . . ] » When the night mode is on, the indicators dim. Apply factory settings You can reset your SoundBar to the default settings programmed at the factory. » When the restore factory settings process is complete, the standby indicator blinks five times. Your SoundBar automatically switches off and back on again. 6 For detailed steps about how to wall mount your SoundBar, refer to Quick start guide. [. . . ]