User manual PHILIPS QC5340/80

[. . . ]  Always unplug this clipper from the electrical outlet immediately after using, except when clipper is (re)charging. The batteries used in this device may present a fire or chemical burn hazard if mistreated. 5 I J K E L  4 When the battery is fully charged, the Charging Light lights up green continuously. Remaining Hair Length Inches MM 1/8 3/16 9/32 3/8 7/16 1/2 5/8 11/16 3/4 13/16 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 Large Comb Barber Setting Remaining Hair Length Inches MM 7/8 1 1 1/16 1 1/8 1 1/4 1 5/16 1 3/8 1 1/2 1 5/8 1 11/16 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 Storage w Be sure Clipper is turned OFF. [. . . ]  lways store your clipper, attachments and A power plug in a moisture-free area. 3 If the charge runs low while clipping, the green Charging Light will turn orange. 4 3 w TIP: Write down the settings you have used to create a certain hairstyle as a reminder for future clipping sessions. 1 Unplug electrical cord from outlet and Clipper before dismantling Clipper. 5 Check if there are any screws in the back or front of the appliance. 6 Remove the back and/or front panel of the appliance with a screwdriver. If necessary, also remove additional screws and/or parts until you see the printed circuit board with the rechargeable batteries. If the charge runs out while clipping, connect cord provided to Clipper and outlet. W Use the Clipper without a comb to clip hair very close to the skin (3/64 in. 1 2 Hair Clipping w Use this Clipper for its intended household use as described in this manual. W Make sure that the appliance is fully charged before you start clipping hair. W Before you start clipping, make sure that the head of the person whose hair you are cutting is at the same level as your chest so that all parts of his/her head are clearly visible and within easy reach. W Before you begin, comb the hair in the direction of growth (fig. W  achieve optimal clipping results, always move To the appliance slowly through the hair against the direction of hair growth. Be careful when you are clipping without comb attachment as when the Clipper is turned on it will remove every hair it touches. 2 To contour the hairline around the ears, comb the hair ends over the ears. 3 Tilt the Clipper in such a way that only one edge of the cutter blades touches the hair ends when you shape the contours around the ears (fig. 4 To contour the nape of the neck or sideburns, turn the Clipper and hold it with the cutter blades pointing downwards (fig. It is suggested that for your protection you return shipments of product by insured mail, insurance prepaid. NOTE: No other warranty, written or oral, is authorized by Philips Electronics North America Corporation. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above exclusion and limitations may not apply to you. [. . . ] 3 Slide the selected comb into the guiding grooves on both sides of Clipper and push until you hear it ‘click’ into place (fig. 4  urn the Zoom Wheel Hair Length Setting T Selector to the desired setting (fig. 5 The selected setting number will appear in the Hair Length Settings Window on the Clipper. When you are clipping for the first time, start at the maximum clipping length setting (#6. [. . . ]