User manual REMINGTON MB-10

[. . . ] Do not use this trimmer with a damaged or broken cutting unit, as facial injury may occur. To disconnect, turn all controls to OFF, then remove adapter from outlet, then detach power cord from the trimmer for storage. It is suggested that you contact local town/city officials to determine proper battery redemption site(s) in your area. When first using, you may want to begin on a higher setting (#9longest hair) to prevent trimming off too much hair initially. [. . . ] S Holding the trimmer horizontally with the cutting unit facing away from you, move the trimmer along the length of the comb. S Hold trimmer horizontally with the cutting unit facing either up or down. S Trim hairs using an upward or downward motion against or with the direction of hair growth, whichever is preferred. S For an even closer "stubble look, " remove the hair length selector attachment and repeat the previous two steps. However, caution must be taken not to remove too much hair, creating a "blotchy" look. S Turn the trimmer so the front of the cutting unit ("Zoom Wheel" side) is facing away from you. S Start trimming under your chin and, following your jawbone line, work toward your ear and upper beard line using an upward motion. Allow the hair length selector attachment to follow the contours of your face. You may trim either against or with the direction of beard growth, whichever is preferred. To trim sideburns s Comb sideburns following the direction of your hair growth. S You will need a hand mirror for this operation if performing it alone. The mirror is not necessary if trimming is performed by a second person. S Use your fingers to lift the hair at the base of your head up off the neck. Your index finger should be covering the roots of the hairs you are lifting to prevent accidental removal by trimmer. S Using your other hand, hold the trimmer horizontally to the base of your neck with the cutting unit facing up, and move the trimmer along the length of the neck until the unit touches your finger covering the hair roots at the base of your head. Be sure to move the unit slowly when performing this operation and to keep the hair roots at the base of your head out of the way of the trimmer. S Use the hand mirror to inspect the results of the operation and ensure all hairs along the nape of the neck have been trimmed. S Start with edge of beard line, and with the cutting blades resting lightly against your skin, use motions towards edge of beard line to trim the beard line to desired location in facial area and away from beard in neck area. With the Pop-Up Trimmer (MB-40, 45 & 50) The small size of this trimmer makes edging and defining mustaches and cutting stray hairs quick and easy. Your trimmer is fitted with high-quality hardened steel or ceramic cutting blades that are permanently lubricated. Cleaning should only be done with a soft brush, such as the brush supplied with the unit. Clean your trimmer regularly to ensure that the unit's operating life is not prematurely shortened. [. . . ] s Pull or gently pry the trimmer halves apart , exposing the batteries. Do not burn or mutilate, as they may burst or release toxic materials. " If you wish, you may mail the product, postpaid, to Remington Products Company L. Remington warrants that your product, except as noted below, is, on date of purchase, free from defect in material and workmanship. [. . . ]