User manual REMINGTON MS-5200

[. . . ] Do not use this appliance with a damaged or broken screen or cutters, as injury may occur. DANGER To reduce the risk of electric shock: Do not reach for an appliance that has fallen into water. Do not place or store this appliance where it can fall or be pulled into a tub or sink while it is plugged in. Except when charging, always unplug this appliance from the electrical outlet immediately after using. Do not use an extension cord or a voltage converter with this appliance. KEEP AWAY FROM CHILDREN SAVE THESE INSTRUCTIONS Contents English . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Spanish . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 French . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25 3 2 CS27660_MB5100/5200_IB 9/1/05 10:38 AM Page 4 Product Features Shaver Parts (A) Screen & cutter assembly (B) Pop-up mini-foil (C) Mini-foil push tab (on back) (D) Beard-lifting fins (E) 3-position trimmer (F) Trimmer push tab (G) ON/OFF button (H) POWER RESERVE button (I) (MS5200 only) (I) Head release button (one on each side) (J) Charging indicators (MS5200 only) (K) Head guard (L) Cleaning brush (M) Travel pouch (B) Titanium MicroScreen 700 ® (A) (E) Congratulations on your purchase of a premium Remington® shaver. [. . . ] Connect the cord to the shaver, then plug the charging adapter into the electrical outlet. Your shaver cannot be overcharged, so you can leave it plugged in and charging between shaves. To preserve the life of the batteries, let them fully run out every six months, then recharge them for a full 24 hours. !Always keep the protective head guard on the shaver head and keep the trimmer in the OFF position when the shaver is not in use. Operating the Trimmer Your shaver is equipped with a 3-position trimmer. Completely retracted (down), the trimmer is out of the way and off, for when you want to use the screens alone. In the middle position, the trimmer works with the screens, cutting the longer, hard-to-shave hairs so the screens can get in extra close. Fully extended (up), the trimmer can be used to trim your sideburns and mustache. Do NOT retract the mini-foil by pressing down directly on the screen. This could permanently damage the screen. 6 7 CS27660_MB5100/5200_IB 9/1/05 10:38 AM Page 8 Usage Tips Adjusting to your new shaver As with every shaver, your shave will improve over time. So allow about three weeks to develop an effective shaving style and for your beard to adjust to the new shaver. The adaptation period may take a little longer if your skin is sensitive, or if you alternate between shaving methods. To help smooth the transition to your new shaver, Remington has applied a special lubricant to the shaver's screens and cutters. The lubricant looks like fine, white or gray powder, and disappears with use. Before you begin Wait at least 15 minutes after getting up before shaving, to ensure your face is free of puffiness that may be present from sleeping. Hold the shaver so all of the screens touch your face at the same time. This allows the shaver to work the way it was designed for the closest shave and minimum wear. Avoid holding the shaver at an angle so only one screen touches the skin at a time. This encourages your whiskers to stand out, making it easier for them to enter the cutting chamber. Pressing only flattens your whiskers, making it harder for them to enter the cutting chamber. Remington® Pre-Shave Powder Stick (SP-5) can help maximize your shaver's performance. Just rub the product over your beard and it absorbs moisture and facial oils, helping set up the hairs so they enter the cutting chamber more easily. It makes shaving quicker and more comfortable. Maintenance Replacing Cutters and Screens To prevent inadvertent damage to the cutters and screens, do not attempt to remove them from the head assembly unless you are replacing them. [. . . ] CAUTION: DO NOT PUT IN FIRE OR MUTILATE YOUR BATTERIES WHEN DISPOSING AS THEY MAY BURST OR RELEASE TOXIC MATERIALS. DISPOSE PROPERLY IN ACCORDANCE WITH YOUR LOCAL AND STATE REQUIREMENTS. Remove the screw from the back of the shaver near the power port. Performance Guarantee Full Two-Year Warranty Rayovac Corporation warrants this product against any defects that are due to faulty material or workmanship for a two-year period from the original date of consumer purchase. This warranty does not include damage to the product resulting from accident or misuse. [. . . ]