User manual REMINGTON MS3-2700

[. . . ] Model Numbers: MS3-1700 MS3-2700 MS3-3700 MS3-4700 s A shaver should never be left unattended when plugged in, except when charging your rechargeable shaver. S Close supervision is necessary when this shaver is used by, on, or near children or invalids. S Use this shaver only for its intended use as described in this manual. Remington® Titanium MicroScreen® Ultra is the world's first shaver with Titanium-coated trimmer blades. [. . . ] Depending on your shaving technique and habits, the screens will usually last six months; the cutters, one year. To prevent inadvertent damage to the screen and cutter assembly, do not attempt to remove them unless you are replacing them. To remove the old screens and cutters follow the instructions that come with the screen and cutter, replacement package. It's always a good idea to replace the screens when you replace the cutters. S Do not push downward on the ends of the cutters, as you may bend the cutter, reducing its ability to operate smoothly. S Do not remove cutters from the plastic pieces to which they are attached, as you may damage the assembly. S Remove the shaver head by squeezing on both side buttons and pulling away from the body of the shaver. You may blow out the stubble thoroughly, or rinse the shaver head in water. Important: Never clean the screen with the enclosed brush as damage may occur to the holes in the screen. S At least once a week, the cutters and the trimmer should be cleaned with the cleaning brush. Do not use an y aggressive cleansing agent as this may destroy the shaver coatings. S To clean and lubricate your shaver's cutters and head assembly, apply Remington® Shaver Saver ® (SP-4) Lubricant. A quick spray after each shave keeps your shaver operating at peak performance. It is very important to replace your screens and cutters when necessary to insure a close, comfortable shave without irritation. Irritation: As foils get worn, you may notice that your skin feels more sensitive after a shave, particularly when you apply after shave. Pulling: As cutters wear, your shave may not feel as close and you may feel your shaver is pulling at your whiskers. Wear-through: You may notice that the cutters have worn through the foil. The replacement for this shaver is model SP-94 for screens and cutters and SP-93 for screens only. Canadian residents: For any shaver accessory requirements, please call 800-268-6531 or write: Remington Products (Canada) Inc. Before operating your shaver, remove the headguard, which protects the screen and cutter assembly. Prior to using your shaver for the first time, put it on charge for 24 hours. S Your shaver cannot be overcharged, so you can leave it plugged in and charging between shaves. [. . . ] S Remove screen assembly by pressing the two side buttons until the head assembly pulls off. Squeeze the ends of the two blade assemblies to bring them into alignment with each other. s Pry and lift the battery assembly up from the printed circuit board. S Cut the wires on both ends of each battery to remove them from the shaver. [. . . ]