User manual REMINGTON R-200

[. . . ] Do not use outdoors or operate where aerosol (spray) products are being used, or where oxygen is being administered. Do not use an extension cord or a voltage converter with this appliance. Do not wrap the cord around the appliance. To disconnect, turn all controls to OFF, then remove plug from outlet. [. . . ] To activate the shaver, slide the power button up to the ON position. Charging the R-400 Before using your shaver for the first time, charge it for 24 hours. NOTE: It may take up to 3 cycles of full charge and discharge to maximize battery capacity. To charge your shaver Slide the power button downward to the OFF position. Connect the supplied AC power cord to the shaver's power port and then 6 to an electrical outlet. The Easy-View pop-up trimmer extends to trim mustache, sideburns, etc. After trimming, pull the trimmer button downward into the OFF position. NOTE (R-400): It is important to always use the button to close the trimmer to avoid damaging the locking mechanism. Operating the Easy-View® Trimmer ® To Trim Trim mustache Use the shaver heads to trim the lower edge of your mustache. Hold shaver at desired trim line for a quick, easy, professional trim. Trim sideburns Extend the trimmer and touch the edge of it to the desired trim line. To Shave Slide the ON/OFF button to activate the shaver for shaving. This allows the shaver to work the way it was designed for the closest 7 Microflex R_200_400_IB 8/24/06 2:34 PM Page 8 Cleaning and Maintenance To assure smooth, efficient performance, it is important to clean your shaver. Lubricate Remington® Shaver Saver® Lubricant (SP-4) lubricates and cleans your shaver's cutters and head assembly. A quick spray after each shave keeps your shaver operating at peak performance. !Important: Make sure to align the two locating holes in the Cutter Retainer assembly with the pins in the Head Frame Assembly. Replace head assembly on the shaver simply by pushing it onto the shaver. When removing the headguard or placing it back onto the shaver, do not apply pressure to floating cutter surfaces, as you may damage them. Cleaning Cautions The construction of this shaver is for dry operation only. Never clean the shaver or replace the cutters while it is plugged into an electrical outlet. Do not use an aggressive cleansing agent as this may destroy the shaver coatings. Do not clean or remove the head assembly while the shaver is running or plugged in, as it may cause damage to the unit's heads or cutters. [. . . ] Lift or pry the battery out of the shaver. CAUTION: DO NOT PUT IN FIRE OR MUTILATE YOUR BATTERIES WHEN DISPOSING AS THEY MAY BURST OR RELEASE TOXIC MATERIALS. DISPOSE PROPERLY IN ACCORDANCE WITH YOUR LOCAL AND STATE REQUIREMENTS. The EPA-certified RBRC® Battery Recycling Seal on the nickel-cadmium (Ni-Cd) battery indicates Spectrum Brands, Inc. [. . . ]