User manual ROSE DISPLAYS ANOKIOSK-STACKABLE

[. . . ] AnoKioskTM Parts Instruction Sheet Bottom Rails with Base Rail Kiosk spine Corner brackets 1a Single rails 1b Split rails Bottom Rails with Stacker Bar Instructions for Assembly Note: We recommended that two people assemble this kiosk. Step 1a Slide spine into vertical rail. Step 1b Slide another vertical rail onto the other edge of spine. Repeat for all vertical rails and spines. 2a 2b Step 2 Carefully insert corner brackets into ends of bottom rails, using thumb as shown in illustration. [. . . ] This is normal. Instruction Sheet (side 2) 4 5 Instructions for Assembly continued Step 5 Insert corner brackets into ends of split rails, 1 per end. Use thumb as shown in illustration. 6 7 Step 6 Assemble split rails onto top ends of vertical rails, one inside and one outside of each side of the AnoKiosk. Step 7 Insert graphics into kiosk with Base Rails. Step 8 Place kiosk with stacker bar on top of first kiosk. Line up stacker bar with split rails on lower kiosk and snap together. Step 9 Load graphics into upper kiosk. Step 10 If there are more kiosks to be stacked repeat steps 8 and 9. Figure 8 Figure 9 The AnoKioskTM is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #02INAnoKioskRigidStackable 35 Congress Street, Salem, MA 01970 Tel# 1- 800 631-9707 Fax# 1-800-560-2890 e-mail:signware@rosedisplays. com Incept-09. 20. 02 AnoKioskTM Parts Instruction Sheet Bottom Rails with Base Rail Kiosk spine Corner brackets 1a Single rails 1b Split rails Bottom Rails with Stacker Bar Instructions for Assembly Note: We recommended that two people assemble this kiosk. Step 1a Slide spine into vertical rail. Step 1b Slide another vertical rail onto the other edge of spine. Repeat for all vertical rails and spines. 2a 2b Step 2 Carefully insert corner brackets into ends of bottom rails, using thumb as shown in illustration. Detail- It is important that the corner bracket tension tab faces toward outside of frame. (2b) 3 Step 3 Lay out parts as they will be configured on the floor. Note: One kiosk will have Base Rail other(s) will have stacker bar. 4-Way 3-Way (Continued on other side) The AnoKioskTM is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. [. . . ] Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #02INAnoKioskRigidStackable 35 Congress Street, Salem, MA 01970 Tel# 1- 800 631-9707 Fax# 1-800-560-2890 e-mail:signware@rosedisplays. com Incept-09. 20. 02 [. . . ]