User manual ROWENTA ADVANCER

[. . . ] Never yank the cord to disconnect from outlet, instead grasp plug and pull to disconnect. - Always disconnect appliance from electrical outlet when filling with water or emptying or when not in use. - Do not operate appliance with a damaged cord or if appliance has been dropped or damaged. - To avoid the risk of electric shock, do not disassemble the appliance. [. . . ] Descaling liquids/agents should not be used. 4 · Filling with Water - Ensure the iron is unplugged. If the iron is equipped with a covered filling inlet, open the filling inlet by sliding the cover down. 4 DZ9080 US 1103898398 10/05/06 11:00 Page 5 - Fill with water (containing no additives) to the max mark on the water tank. We recommend using the enclosed filling cup rather than filling under the tap. If you need to add water during ironing, UNPLUG the iron and follow the steps above. Ensure iron heats back to temperature afterwards, that means thermostat light will go out. 5 · Selecting the Temperature The digital Temperature Control Dial allows you to closely monitor the temperature of the soleplate. Set the temperature control dial according to the fabric you are ironing. We recommend using the chart below as a guide. Ironing label Fabric Synthetic fibers e. g. viscose, polyester Silk, wool Temperature control Cotton, linen 5 DZ9080 US 1103898398 10/05/06 11:00 Page 6 YELLOW LIGHT The iron is heating up to reach the selected temperature. The temperature of the soleplate is too high for the selected setting. Move the iron gently to reactivate it. GREEN LIGHT NO OK RED LIGHT AUTO-OFF IMPORTANT!We recommend that you start with fabrics to be ironed at a low temperature. TIP Always spray starch onto the reverse side of the fabric to be ironed. 6 · Dry Ironing To iron without steam, slide the variable steam control lever to the position. Set the temperature for the type of material to be ironed. 7 · Steam Ironing You can steam iron from temperature setting ·· up. The steam quantity can be adjusted batween Smooth Steam (soft steam continous diffusion) up tu High Pressure Steam. We recommanded stetting to High Pressure Steam only when the iron is at temperature setting ···. Use caution and do not direct soleplate at people, animals, etc. 6 DZ9080 US 1103898398 10/05/06 11:00 Page 7 Before ironing for the first time fill iron and allow to heat. The iron should be allowed to emit steam for at least 1 minute to remove any impurities. This should also be done if iron isn't used regularly. 8 · High Pressure Steam Your iron is fitted with the new High Pressure Steam system. This technology generates higher steam pressure to enable the steam to penetrate much faster and further into the fabric. This is not a technical fault! 9 · Burst of Steam This feature is ideal for removing stubborn wrinkles or pressing in sharp creases. When the temperature control is set to a steam setting (·· or ···) the burst of steam can be used. Leave an interval of at least four seconds between bursts. 10 · Vertical Steam This feature is ideal for hanging clothes, drapes, curtains, etc. [. . . ] This warranty does not apply to any defect arising from a buyer's or user's misuse of the product, negligence, failure to follow Rowenta's instructions, use on current or voltage other than stamped on the product or alteration or repair not authorized by Rowenta. Repair or disassembly by anyone other than a Rowenta authorized service center will void the warranty. THE WARRANTIES SET FORTH HERE IN ARE EXCLUSIVE AND NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE OR USE, ARE MADE BY ROWENTA OR ARE AUTHORIZED TO BE MADE WITH RESPECT TO THE PRODUCT. ROWENTA'S SOLE OBLIGATION IN THE EVENT OF A DEFECTIVE PRODUCT SHALL BE TO REPAIR OR REPLACE, AT ROWENTA'S SOLE DISCRETION, THE DEFECTIVE PRODUCT. [. . . ]