User manual ROWENTA DG 5030

[. . . ] Incorrect reassembly can cause a risk of electric shock when the appliance is used. Close supervision is necessary for any appliance being used near children. Do not leave appliance unattended while plugged in, on an ironing board, or while it is still hot. -Never attempt to unscrew the boiler cap while the appliance is in use. [. . . ] Never use 100% pure distilled water. Always remember : Battery water and water containing additives (such as starch, perfume or fabric conditioner) may not be used. Such additives can affect the 4 1800113197 -matt GRD:1800111395 GRD 28/02/08 9:17 Page 5 4 · Steam ironing Never iron or steam clothes while they are being worn. The appliance allows steam output to be adjusted (depending on model). · setting on the iron : the steam control dial should be set to min. ·· setting on the iron : the steam control should be set at the mid level. ··· setting on the iron : the steam control dial can be set to the max. TYPE OF FABRIC 5 · Dry ironing This appliance can be used for dry ironing if the steam trigger is not pressed and the steam control dial is set to min. Set the iron's on/off switch to the on position. 6 · Vertical steam To remove wrinkles in cotton or linen, the soleplate can come into contact with the fabric for optimal results. For synthetic fabrics, a distance of 4 inches is recommended to avoid damage to the garment. For delicate fabrics, we recommend carrying out a test on an unobtrusive part of the garment (inner seam). To avoid burns and scalding never iron or steam clothes while they are being worn. Fill iron according to the "Filling the boiler" section of instructions. Press on/off switch (B), the iron light and steam indicator light will turn on. When the steam indicator light turns off (approximately 11 minutes), steam is ready. Hang the garment on a coat hanger and hold the fabric from the bottom of the garment slightly taut with one hand. Holding the iron in a vertical position, press continuously on the steam button while moving the iron from the top of the garment to the bottom (C). If unit is left on without steaming for a length of time, water can condense in the hose and droplets of water can be seen when you begin to use the pressure iron & steamer again. For best results simply aim the iron away from yourself, other people, animals and clothing and press the trigger for a few seconds to remove the condensation and steam begins to fill the hose. IRON THERMOSTAT SETTING STEAM CONTROL DIAL SETTING LINEN, COTTON WOOL, SILK SYNTHETIC (Viscose, Polyester) ··· ·· · Note : It is normal for the connection cord to become warm during use. Before using the pressure iron & steamer for the first time or if you have not used the steam function for a few minutes, press the steam button several times in a row while holding the iron away from your clothes. This will enable any cold water to be removed from the steam connection cord. When ironing start with fabrics that require a low temperature setting (·) and finish with those which need the highest temperature (···). Mixed fiber fabrics should be ironed on the temperature for the most delicate fabric. For example a shirt that is 60% cotton and 40% polyester should be ironed at the (·) setting for synthetics. [. . . ] Tel: (781) 396-0600 www. rowentausa. com OFFICE LOCATION ONLY Letters will be accepted at this address and packages without a return authorization number will be refused or forwarded to a service center. If your appliance needs service, ship the product to your nearest regional service center. Include a brief note describing the issue, and include a copy of the sales receipt if the product is in warranty. If in warranty, Rowenta will repair or replace the product at their discretion. [. . . ]