User manual ROWENTA DW6010 ECO INTELLIGENCE

[. . . ] € Never leave the appliance unattended when it is connected to a power source ; if it has not cooled down for approximately 1 hour. € Your appliance gives off steam, which may cause burns, especially when you are ironing close to the edge of your ironing board. € Your iron should be used and placed on a flat, stable, heat-resistant surface. [. . . ] TIP Always spray starch onto the reverse side of the fabric to be ironed. 11) and set the temperature to suit the type Your Steam Iron is equipped with the Eco Steam System. This function offers 3 steam settings for optimal ironing: - DRY position: For an ironing without steam, ideal for delicates or perfect finishes. - ECO position: For an optimized ironing with a steam output perfectly adapted to all fabric types. - BOOST position: For increased variable steam output to reach perfect result on thickest fabrics. 5 • Eco steam system 6 • Shot of steam (from temperature setting •• upwards) Press the shot of steam button to generate a powerful jet of steam (fig. Wait a few seconds between each shot before pressing the button again. (from temperature setting •• upwards) TIP Hold the iron 10 to 20 centimetres away from the garment to avoid burning delicate fabrics. 7 • Vertical shot of steam Hold the iron to the vertical and press the shot of steam button ( fig. 17) to remove creases from suits, jackets, skirts, hanging curtains etc. Wait a few seconds between each shot before pressing the button again. FR 9 • Anti-Drip system* This prevents water escaping from the soleplate when the temperature is too low. 10 • Automatic electronic 3-position cut-out* If, although switched on, the appliance is not moved, it will automatically switch off and EN the auto off light will blink after the following intervals: - After 30 sec. , if the iron is left resting on the the soleplate or lying on its side. [. . . ] Solution Check that the mains plug is properly inserted or try plugging the iron into a different socket. Ensure linen is rinsed thoroughly to remove any soap deposits or chemicals on new garments which may be sucked by the iron. Always spray starch onto the reverse side of the fabric to be ironed and clean your iron soleplate. [. . . ]