User manual ROWENTA DW9210D5

[. . . ] Never leave the appliance unattended when it is connected to a power source; if it has not cooled down for approximately 1 hour. Take care especially when you are ironing on a corner of your ironing board. For best results we recommend that you use a mesh type ironing board to enable the steam to pass through the fabric and avoid steam venting sideways. Your iron should be used and placed on a flat, stable, heat-resistant surface. [. . . ] This position is marked on the dial and also represented with a louder “click” sound. You can also set your iron based on the international temperature measurements •, ••, •••. When your iron reaches the required temperature, the thermostat indicator turns off fig. Viscose, polyester) THERMOSTAT THERMOSTAT IRONING INDICATION LABEL NYLON silk SILK wool WOOL cotton COTTON linen LINEN IMPORTANT The iron takes longer to cool down than to heat up. We recommend that you start with fabrics to be ironed at a low temperature. TIP Always spray starch onto the reverse side of the fabric to be ironed. 3 • Dry ironing Set the temperature to suit the type of material without pushing the autosteam trigger and shot of steam button. 4 • Steam ironing (Autosteam & Steamforce) Your iron is equipped with the Autosteam function. The steam quantity and the temperature will adjust automatically to the selected fabric. Your iron is equipped with a pump called Steamforce Technology which pushes 30 % more steam into the heart of the fibres. 5 • Shot of steam Press the shot of steam button to generate a powerful jet of steam fig. IMPORTANT Leave an interval of a few seconds between each shot and wait until the flow of steam has finished before standing the iron on its heel. 3 DW9020-30-1103905566:FerClassic_BASE_110x220mm 3/02/09 17:22 Page 4 6 • Vertical shot of steam (from temperature setting (••) upwards) Hold the iron vertically and press the shot of steam button to remove creases from suits, jackets, skirts, hanging curtains etc. TIP Hold the iron 10 to 20 centimetres away from the garment to avoid burning delicate fabrics. 7 • Spray Press the spray button to dampen difficult creases fig. 8 • Anti-Drip system * It prevents water escaping from the soleplate when the temperature is too low. 9 • Auto Off function* • For your safety, the electronic system cuts off the power and the auto off indicator light flashes fig. 12 when: - The iron remains motionless for more than 8 minutes on its heel. - To restart the iron, just move it gently until the warning light stops flashing. 11 • Storing Allow the appliance to cool down before storing the iron standing on its heel. [. . . ] * Thermostat control light goes on and off None or too little steam is being emitted. Brown streaks come through the holes in the soleplate and stain the fabric. Do not add any descaling agents, perfumed, or scented additives to the water in the water tank. Use the Self Clean function and clean your iron if you have used the above. [. . . ]