User manual ROWENTA EXPRESSO SILVER ART

[. . . ] For your safety, the filter holder is fitted with a locking system so that it remains in place when the pressure rises. eN 1- DESCRIPTION a b c d Water tank cover Removable water tank Cup tray Control panel: d. 1 Selection knob (coffee or steam) e Position for the filter holder f Filter holder with ejection system for the used coffee or pod and progressive compression of the ground coffee or pod: OPTIPRESS system. steam nozzle Drip tray grill Drip tray with level indicator Power cord d. [. . . ] € Release the filter holder by pressing the button lightly and turning it towards the left (fig. If required, remove the paper around the pod following the dotted lines (fig. E pod with the red writing facing downwards (fold the corners of the filter paper back). Ensure that the paper is placed inside the filter, otherwise this could cause leaks. € Insert the filter holder into the appliance tightening it by turning it towards the right as far as possible (fig. € To prepare your espresso, follow the same procedure as for the preparation of an espresso with ground coffee. With a soft pod Your machine is also compatible with soft pods (generally 60 mm in diameter). As this type of pod is not specifically designed for espresso machines, you will obtain a weaker espresso than with an E. € Before removing the removable tank, remember to place the selector d1 in the position (fig. € Fill the tank with cold water and fit it back onto the appliance (fig. € Release the filter holder by pressing the button lightly and turning it towards the left (fig. € In order to give the milk plenty of froth, move the appliance in a circular direction from top to bottom (fig. 19), making sure that the steam nozzle remains upright at the centre of the container. € To obtain a good froth on your milk, we recommend that you use fresh cold pasteurised semi-skimmed milk, skimmed milk or UHT milk. € During operation, it is normal for the temperature light of the ON/OFF button to light up and then extinguish. • When frothing is completed , stop the appliance device (switch d1 in position )). € When the selector d1 is in the position , the appliance cools down automatically. During the cooling down phase, the LED of the ON/OFF button flashes, and hot water runs into the drip tray. When the optimal temperature for preparing an espresso is reached, the LED remains lit. Once the steam has been stopped, clean the steam nozzle immediately and thoroughly using a damp sponge (to avoid residues from sticking) and let a little more steam run through into free air to rinse the inside of the nozzle. The filter holder The appliance that you have purchased is equipped with a removable ejecting filter holder, which allows you to maintain it in perfect working order. These removal/fitting operations must be carried out when the machine has cooled down. [. . . ] If the problem continues, do not use the appliance, contact an approved service centre. Switch off the appliance (position ), fill the water tank and switch back on. 10 IFU_RO_PERFECTO_4400_NC00025894-01_eo 27/09/11 11:26 Page11 Problems The cups are not filled equally. Fit the filter holder in place and lock it (turn it from left to right as far as possible) (fig. [. . . ]