User manual ROWENTA FOCUS DW5122D1

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual ROWENTA FOCUS DW5122D1. We hope that this ROWENTA FOCUS DW5122D1 user guide will be useful to you.


ROWENTA FOCUS DW5122D1 : Download the complete user guide (2648 Ko)

Manual abstract: user guide ROWENTA FOCUS DW5122D1

Detailed instructions for use are in the User's Guide.

[. . . ] Connecting to the wrong voltage may cause irreversible damage to the iron and will invalidate the guarantee. € If you are using a mains extension lead, ensure that it is corrected rated (16A) with an earth, and is fully extended. € If the electric power cord is damaged, it must be replaced by an Approved Service Centre in order to prevent any danger. € Your appliance gives off steam, which may cause burns, especially when you are ironing close to the edge of your ironing board. [. . . ] Any commercial use, inappropriate use or failure to comply with the instructions, the manufacturer accepts no responsibility and the guarantee will not apply. Position * c Eco position Anti Calc Spray button Shot of steam button 7 8 9 10 11 12 13 14 Cord Handle Thermostat control light Temperature control dial Water tank Maximum water level indicator Soleplate Auto-Off* 4 5 6 BEFORE USE WARNING !Before using your iron with the steam function for the first time, we recommend that you operate it in a horizontal position for a few moments, away from your linen, i. Upon the first use, you may notice small particles coming out of the soleplate. This is parf of manufacturing process and is not harmful to you or your garments. You may accelerate this by using the Anti Calc function (fig 5a – 5b) and shaking the iron gently. However, if your water is very hard, you can mix 50% untreated tap water with 50% distilled or demineralised water. IMPORTANT Heat concentrates the elements contained in water during evaporation. The types of water listed below contain organic waste or mineral elements that can cause spitting, brown staining or premature wear of the appliance : water from clothes dryers, scented or softened water, water from refrigerators, batteries or air conditioners, pure distilled or demineralised water or rain water should not be used in your iron. IRONING BOARD: Due to the powerful steam output, a mesh type ironing board must be used to allow any excess steam to escape and to avoid steam venting sideways. (*) Depending on model 2 1103912668-01 DW5000 F1 ECO_110x220mm 24/02/15 14:33 Page3 USE 2 • Filling the water tank IMPORTANT Before filling the water tank, unplug the iron and set the steam control to dry position . 13 • Anti-scale system Your iron contains an anti-scale cartridge to reduce scale deposits. The anti-scale cartridge is an integral part of the water tank and does not need to be replaced. IMPORTANT Do not use descaling agents, as these damage the lining of the steam chamber and so may impair the steam function. 14 • Anti Calc function (prolongs the life of the iron) The Anti Calc function flushes dirt and scale particles out of the steam chamber. Fill the water tank with untreated tap water up to the max mark and heat the iron to the ••• temperature. After a few seconds water will emerge from the soleplate, rinsing dirt and scale particles out of the steam chamber. 15 • Cleaning the iron When the appliance has cooled down, wipe it down with a damp cloth or sponge, as required. IMPORTANT Do not use sharp or abrasive cleaning agents or objects to clean soleplate and other parts of the iron. If the appliance has been standing unused for long periods, use the Anti Calc function (see § 14). 16 • Eco steam system ECO position: For an optimized ironing with a steam output perfectly adapted to all fabric types. (*) Depending on model 4 1103912668-01 DW5000 F1 ECO_110x220mm 24/02/15 14:33 Page5 PROBLEMS? [. . . ] (*) Depending on model 4 1103912668-01 DW5000 F1 ECO_110x220mm 24/02/15 14:33 Page5 PROBLEMS?Problems The iron is plugged in, but the soleplate of the iron remains cold. Solution Check that the mains plug is properly inserted or try plugging the iron into a different socket. Ensure linen is rinsed thoroughly to remove any soap deposits or chemicals on new garments which may be sucked by the iron. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE ROWENTA FOCUS DW5122D1




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual ROWENTA FOCUS DW5122D1 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.