User manual ROWENTA IS6200D1 COMPACT VALET

[. . . ] To reduce the risk of electrical shock, do not disassemble or attempt to repair the appliance, take it to a qualified service person for examination and repair. Incorrect reassembly or repair could cause a risk of fire, electric shock, or injury to persons when the appliance is used. - Close supervision is required for any appliance used by or near children. - This appliance is not intended for use by or near children and other persons whose physical, sensory or mental capabilities or lack of experience and knowledge prevents them from using the appliance safely without supervision or instruction by a responsible person to ensure that they can use the appliance safely. [. . . ] To steam trousers, we recommend that you also use the support with clips as indicated in the illustration. 14) • Grasp the steam head with the steam vents pointing away from you. €¢ Start steaming by brushing material lightly with the grain of the fabric in an up/down vertical motion. The fabric brush opens the weave of the fabrics for better steam penetration. €¢ Start at the top the garment and gradually move downward (fig. €¢ For more ease, we recommend to pull the garment downward with your free hand while steaming. If the device begins to gurgle, rest the steam head on its support for a few moments in order to direct the condensation into the device once again. ACCESSORIES Before using an accessory, check the manufacturer recommendations. It is also recommend that you carry out a test on part of the fabric which cannot be seen. Fabric brush The fabric brush opens the weave of the fabrics for better steam penetration. Be sure unit is unplugged and completely cool before attaching accesories. €¢ Attach the fabric brush to the steam head by lining up the bottom of the brush with the bottom of the steam head. Gently push the top of the brush onto the steam head until it clicks into place. €¢ Gently brush the area to be steamed with the grain or nap of the fabric. €¢ Remove the fabric brush once unit is unplugged and completely cool. Remove it by pressing on the release tab on top of brush while pulling it forward. 20 1800124023 IS6200 US_110X154 30/08/11 14:35 Page21 Crease attachment • Remove the fabric brush. Completely slide the hook of the accessory into the slot located in the lower part of the steam head. €¢ Place the garment between the crease attachment and steam head. €¢ Starting at the top of the garment, move the crease attachment in a downwards motion. €¢ Once unit is unplugged and completely cooled down, remove the crease attachment by sliding it off of the steam head. Lint pad The lint pad is a separate accessory and cannot be attached to the steam head. [. . . ] Com) or by calling the appropriate telephone number listed below to request the appropriate postal address. Rowenta shall not be obligated to repair or replace any product which is not accompanied by a valid proof of purchase. This warranty will not cover any damage which could occur as a result of misuse, negligence, failure to follow Rowenta instructions, use on current or voltage other than as stamped on the product, or a modification or unauthorized repair of the product. It also does not cover normal tear and wear, maintenance or replacement of consumable parts, and the following: - using the wrong type of water - scaling (any de-scaling must be carried out according to the instructions for use); - ingress of water, dust or insects into the product; - mechanical damages, overloading - damages or bad results due to wrong voltage or frequency - accidents including fire, flood, lightning, etc - professional or commercial use - damage to any glass or porcelain ware in the product This warranty does not apply to any product that has been tampered with, or to damages incurred through improper use and care, faulty packaging by the owner or mishandling by any carrier. [. . . ]