User manual ROWENTA OR8040

[. . . ] Check that the voltage of your electricity supply matches the voltage of your appliance. Any error when connecting the appliance can cause irreparable harm, not covered by the guarantee. As an additional safety measure, we recommend the installation of a residual current difference device in the electrical circuit supplying the bathroom, acting at not more than 30 mA. [. . . ] As an additional safety measure, we recommend the installation of a residual current difference device in the electrical circuit supplying the bathroom, acting at not more than 30 mA. The installation of the appliance and its use must however comply with the standards in force in your country. CAUTION: Never use your appliance with wet hands or near water contained in bath tubs, showers, sinks or other containers. When using the appliance in the bathroom, unplug it after use as the presence of water nearby may pose a danger even when the appliance is turned off. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. Stop using your appliance and contact an Authorised Service Centre if: - your appliance has fallen. Close the pincers, using the Lock System (K) catch, unplug the appliance and allow it to cool down completely before storing. Automatic cut out: For your safety the appliance will cut out automatically after 60 min. If you wish to turn it on again follow the instructions given in SWITCHING ON. This appliance must be used in the right direction: make sure the ULTRA TENSION system (D) is facing down (fig. Take a lock of hair a few centimetres long, comb it and place it between the plates (Fig. 2) Close the plates and slide the appliance slowly from the roots towards the tips of the hair (Fig. The coating on the plates protects your hair from high temperatures by distributing the heat evenly. Work from the back of the neck first before going onto the side of the head and finish with the front. [. . . ] 2) Close the plates and slide the appliance slowly from the roots towards the tips of the hair (Fig. The coating on the plates protects your hair from high temperatures by distributing the heat evenly. Work from the back of the neck first before going onto the side of the head and finish with the front. [. . . ]