User manual ROWENTA PERFECTO DUO

[. . . ] For your safety, your filter holder is equipped with a locking system to keep it in place when the pressure rises. EN 2 - SAFETY INSTRUCTIONS   Read the instructions for use carefully before using your appliance for the first time: the manufacturer shall accept no liability in the event of any improper use. For your safety, this appliance complies with applicable standards and laws: - Low Voltage Directiven - Electromagnetic Compatibility - Environment - Materials in contact with food Always plug the appliance into an earthed socket. Please check that the voltage indicated on the name plate of the appliance corresponds to your electrical installation. [. . . ] € Remove any excess ground coffee from the edge of the filter holder (Fig. € Insert the filter holder in the appliance by turning it to the right up to the stop (Fig. € Put one or two cups on the drip tray grid under the filter holder (Fig. € When your cups are full, move the selector d1 to the position (Fig. € Unlock the filter holder: press the button lightly while turning the filter holder to the left and remove it from the appliance. Throw away the used grounds using the ejection system by pressing the “Push” button under the filter holder (Fig. Wash the filter holder under running water, pressing the “Push” button to eliminate the remaining grounds (see also Paragraph 8. It is normal that every time the selector dial d1 returns to the position there is a slight noise of running water or steam. This is due to a specific device which eliminates the pressure built up within the system. E espresso pod “ESE” for “Easy Serving Espresso” is a packaged pod (44 mm diameter) of 7g of selected coffee, ground and compacted between two paper filters, specially designed to make Italian style ristretto (small and strong) espressos. This system allows an immediate, simple, clean and comfortable use of your machine. Once the froth has been formed, switch off the appliance (selector dial d1 in position). When the selector dial d1 is in position, the appliance will automatically cool down. During the cooling down phase, the LED of the ON/OFF button will flash, and hot water and/or steam will run into the drip tray. When the optimal temperature for preparing an espresso is reached, the LED remains lit. Once the steam has been stopped, clean the steam nozzle immediately as described in Paragraph 8D WARNING!€ • • • • • • The appliance Unplug the power supply before cleaning and let the appliance cool down. Clean the outside of the appliance from time to time with a damp sponge. When a fine white film obscures the tank, carry out a descaling operation (see. To clean the hot water drip-through grid, regularly carry out an espresso preparation without coffee. The frequency of descaling should be adapted to the hardness of your water. During the operation, do not stand your appliance on a marble surface. [. . . ] If the problem continues, do not use the appliance, contact an approved service centre EN Cracking noises normal: safety are heard from the This is filter holder lock on the filter holder The pump is abnormally noisy The cups are not filled equally No water in the tank Tank incorrectly fitted The filter holder is clogged The filter holder is not fitted correctly The espresso leaks from the sides of the filter holder The edge of the filter holder has ground coffee on it Switch off the appliance, fill the water tank and switch back on Press firmly on the tank Clean the filter holder (see Paragraph 8b) Fit the filter holder in place and lock it (turn it towards the right as far as possible up to the stop) Remove the excess ground coffee Pod not correctly positioned Place all the paper inside the filter holder in the filter Your espresso tastes bad After descaling, the rinsing was not performed Rinse the appliance according to the instructions (see Paragraph 9) properly The pump was unprimed due to lack of water The water tank is not properly clicked in place The steam nozzle is blocked or scaled up The steam nozzle does not froth the milk The milk is too hot The container is not the right shape You are using skim milk The grind is too old The espresso is not frothy The grind is not suitable for espresso There is too little grind in the filter holder Fill the water tank and reprime the pump (see Paragraph 5). Avoid completely emptying the tank Click the tank into place by pressing firmly Descale the steam nozzle (see Paragraph 9) or unblock it with a needle Use cold milk Use a small pitcher Preferably use whole or semi-skimmed milk Use freshly ground coffee Use a finer grind Add some more grind The appliance does not work 30 RO_COMBI_NC00025872-01_EO_rowenta 20/09/11 17:34 Page31 12 - FILTER COFFEE MAKER EN USING FOR THE FIRST TIME Operate the coffee maker for the first time, without ground coffee, by filling the water tank with 1 litre of water and pressing the on/off button on the coffee maker (G) to rinse the circuit. MAKING COFFEE (Follow the illustrations 19 to 24) - Use only cold water and filter paper no. - Do not exceed the maximum amount of water indicated on the tank water level. [. . . ]