User manual ROWENTA PROFESSIONAL 1

[. . . ] The use of accessory attachments is not recommended by Rowenta Appliance Company and may result in fire, electric shock or personal injury. 2 SPECIAL INSTRUCTIONS 1. This is a 1200 watt or 1400 watt appliance (check rating on iron heel). [. . . ] SETTING VARIABLE STEAM CONTROL Set the variable steam control to required steam volume. Steam can only be produced when the thermostat is in the red cotton/linen zone. Allow iron to heat up (light goes out) before activating the variable steam control. Reduce or set variable steam to min when ironing at low temperatures to avoid water leakage or spitting. Iron ready for steam ironing: Steam is produced as soon as the iron is held horizontally. Steam off: Steam generation can be interrupted by standing the iron on its heel or sliding the variable steam control fully to the left. Moistening the fabric with the spray will make wrinkle removal easier. Press the spray button down slowly for a jet or quickly and strongly for a mist. Do not spray silk, etc. BURST OF STEAM To remove stubborn wrinkles or press in a sharp crease, use the burst of steam button. Press the button firmly, a strong burst of steam penetrates deep into the fabric. Leave an interval of at least four seconds between pressing the burst of steam button. With water in the tank, the burst of steam button can be used as soon as the steam ironing temperature has been reached (q q q) 6 VERTICAL STEAM (NOT ON ALL MODELS) The iron can also be used vertically. [. . . ] To ensure your iron continues to steam efficiently the valve MUST be opened and closed a few times. This is done by moving the variable steam control left to right a few times each time you finish ironing. [. . . ]