User manual ROWENTA RH8469

[. . . ] €¢ Do not store the appliance outdoors and keep it in a cool, dry place at all times. €¢ Do not place the appliance near a heat source (ovens, electric heaters or hot radiators). €¢ Do not expose the batteries to a room temperature above 104ºF (40°C). €¢ Never use your vacuum cleaner without the dust tray and the foam rubber motor protection filter. [. . . ] €¢ « Max » : Used for optimum vacuum performance on all floor types, and in case of strong dirt marks (2. Speed 1 Speed Vacuum cleaner running times* for each usage speed (with a fully charged battery):2 « Min » « Max » 12 Volts Up to 25 minutes Up to 15 minutes USING THE ELECTRO-BRUSH The electro-brush is a rotating, motorized brush that guarantees maximum cleaning effectiveness by allowing the appliance to suck up dirt and clean in depth. The bristles, located all along the brush, remove threads, hair and fur that might be caught on the surface of rugs and carpets. Please note: If the vacuum head adheres too closely to the surface you are cleaning, change the speed to « Min ». ATTENTION: Do not vacuum large fragments of broken objects, as they could block and damage the brush. Do not use the electro-brush on long hair carpets, on animal fur, or on fringes. REMOVING AND CLEANING THE ELECTRO-BRUSH ATTENTION: Always turn off the appliance and unplug it before storing or cleaning. 14 * May vary according to model RO_Aspirateur_AIR_FORCE_UPGRADE_903121-02_Mise en page 1 20/12/12 10:17 Page15 Using the tool provided with the appliance (15), press in the two latches located on each side of the lower side of the Delta head (fig. Remove the electro-brush and its lateral bearing in order to clean them (fig. Finally, using the tool provided with the appliance, close both latches (fig. FOR YOUR SAFETY • Do not touch any rotating parts before you turn off and unplug the vacuum cleaner. ELECTRO-BRUSH MALFUNCTION The electro-brush does not function properly or makes an unusual sound • Either the rotating brush or the axis is blocked: turn off the appliance and clean them. €¢ The brush is worn out: visit an authorized Service Center in order to have the brush changed. €¢ The belt is worn out: if the belt makes noise, it means that it is slipping because it’s worn out. The electro-brush stops while you are vacuuming • The thermal security feature has been activated: Turn off the vacuum cleaner by moving the Stop/Start button to the Stop position (2. Check to see if any solid object is blocking the rotation of the brush. If this is the case, remove the object and clean the electro-brush (fig. The electro-brush moves with difficulty If you find that your vacuum cleaner slides with difficulty along surfaces, progressively reduce the speed until you reach the « Min » position (2. If the problem persists, take your appliance to the authorized Rowenta Service Center nearest to your home. See the list of authorized Rowenta Service Centers or contact the Rowenta Consummer Service department. 4 • Storage After use, turn off your vacuum cleaner by moving the Stop/Start button to the Stop position (2a). Now you may store your appliance vertically wherever you like, thanks to the parking position. [. . . ] • The foam rubber motor protection filter is saturated: clean it. If the separator gets filled with dust • The separator sometimes accumulates dust. Make sure that nothing is blocking the duct between the separator and the dust tray. €¢ The dust tray opening is blocked: Remove the dust tray, empty it and clean the opening. [. . . ]